CORBERO HSG-PF320SX-1 Installatie- en gebruikershandleiding - Pagina 8

Blader online of download pdf Installatie- en gebruikershandleiding voor {categorie_naam} CORBERO HSG-PF320SX-1. CORBERO HSG-PF320SX-1 12 pagina's.

ELECTRICAL CONNECTION

This appliance must be connected by a competent person, using fixed wiring via a double pole switched fused spur outlet

with a fuse rating of 3amps, and with a contact separation of at least 3mm in all poles.

We recommend that the appliance is connected by a qualified electrician who will comply with I.E.E regulations.

The wires in the mains lead are colored in accordance with the following code: Green & Yellow = Earth, Blue = Neutral,

Brown = Live

Caution! Voltage of heating elements 220V

Caution! In the event of any connection the safety

Wire must be connected to the

connection, bridges connect L

terminals and N terminals, safety

USER INSTRUCTIONS

1. To light the hotplate push in the appropriate control knob and turn anti-clockwise to the large flame symbol (fig. 8).

2. Keep the knob depressed until the burner lights.

3. Turn the tap to the required setting.

4. In the event of the burner flames being accidentally extinguished, turn off the burner control and don't attempt to

reignite the burner for at least 1 min.

NOTE: Matches can be used to light the burners in the event of a power failure. Keep the control knob pressed in for 15

seconds ensuring the burner stays lit when released. If the burner fails to stay lit wait for 1 minute before relighting.

Closed position

Full on position

Reduced rate position

SELECT THE RIGHT BURNER

Use an appropriately sized pan and with flat bottom for each burner (see the table below and fig. 9).

When the contents of the pan start to boil, turn the knob down to reduced rate position. Always put a lid on the pan

WARNING

NOTE: Please not use cooking vessels that overlap the boundaries of the hob

For 220V earthed one-phase

wire to

PE terminal.

Recommended

type of

connection lead