HIKOKI G 10VE2 Handling Instructies Handleiding - Pagina 11

Blader online of download pdf Handling Instructies Handleiding voor {categorie_naam} HIKOKI G 10VE2. HIKOKI G 10VE2 20 pagina's.

MAINTENANCE AND INSPECTION

WARNING

Be sure to switch power OFF and disconnect the plug from

the receptacle during maintenance and inspection.

1. Inspecting the depressed center wheel

Ensure that the depressed center wheel is free of cracks

and surface defects.

2. Inspecting the mounting screws

Regularly inspect all mounting screws and ensure that

they are properly tightened. Should any of the screws be

loose, retighten them immediately. Failure to do so could

result in serious hazard.

3. Replacing supply cord

If the replacement of the supply cord is necessary, it

has to be done by HiKOKI Authorized Service Center to

avoid a safety hazard.

4. Filter cleaning and inspection

WARNING

Wear protective glasses and a dust mask when cleaning

the ﬁ lter with an air blow gun.

Failure to do so may result in inhalation or exposure of

the eyes to debris or dust.

After use, remove any debris or dust adhered to the ﬁ lter

using a soft brush. (Fig. 10) Check the ﬁ lter periodically

to ensure that it is free of scratching, chipping, or tearing.

Replace with a new ﬁ lter if the ﬁ lter is damaged in any way.

NOTE

If the mesh is clogged and the debris or dust cannot be

removed, detach the ﬁ lter and clean it with an air gun, etc.

(See "Mounting and dismounting the ﬁ lter set (Fig. 11)")

5. Maintenance of the motor

The motor unit winding is the very "heart" of the power

tool. Exercise due care to ensure the winding does not

become damaged and/or wet with oil or water.

NOTE

In order to expel debris and dust, periodically run the

motor with no load.

CAUTION

In the operation and maintenance of power tools, the

safety regulations and standards prescribed in each

country must be observed.

NOTE

Due to HiKOKI's continuing program of research and

development, the speciﬁ cations herein are subject to

change without prior notice.

English