HIKOKI G 10VE2 Manual de Instruções de Manuseamento - Página 11

Procurar online ou descarregar pdf Manual de Instruções de Manuseamento para Moedor HIKOKI G 10VE2. HIKOKI G 10VE2 20 páginas.

MAINTENANCE AND INSPECTION
WARNING
Be sure to switch power OFF and disconnect the plug from
the receptacle during maintenance and inspection.
1. Inspecting the depressed center wheel
Ensure that the depressed center wheel is free of cracks
and surface defects.
2. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that
they are properly tightened. Should any of the screws be
loose, retighten them immediately. Failure to do so could
result in serious hazard.
3. Replacing supply cord
If the replacement of the supply cord is necessary, it
has to be done by HiKOKI Authorized Service Center to
avoid a safety hazard.
4. Filter cleaning and inspection
WARNING
Wear protective glasses and a dust mask when cleaning
the fi lter with an air blow gun.
Failure to do so may result in inhalation or exposure of
the eyes to debris or dust.
After use, remove any debris or dust adhered to the fi lter
using a soft brush. (Fig. 10) Check the fi lter periodically
to ensure that it is free of scratching, chipping, or tearing.
Replace with a new fi lter if the fi lter is damaged in any way.
NOTE
If the mesh is clogged and the debris or dust cannot be
removed, detach the fi lter and clean it with an air gun, etc.
(See "Mounting and dismounting the fi lter set (Fig. 11)")
5. Maintenance of the motor
The motor unit winding is the very "heart" of the power
tool. Exercise due care to ensure the winding does not
become damaged and/or wet with oil or water.
NOTE
In order to expel debris and dust, periodically run the
motor with no load.
CAUTION
In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each
country must be observed.
NOTE
Due to HiKOKI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
11
English