Deagostini MODEL SPACE Honda CB750 FOUR Montagehandleiding - Pagina 10

Blader online of download pdf Montagehandleiding voor {categorie_naam} Deagostini MODEL SPACE Honda CB750 FOUR. Deagostini MODEL SPACE Honda CB750 FOUR 16 pagina's. Pack 12
Ook voor Deagostini MODEL SPACE Honda CB750 FOUR: Montagehandleiding (16 pagina's), Montagehandleiding (16 pagina's), Montagehandleiding (20 pagina's), Montagehandleiding (16 pagina's), Montagehandleiding (16 pagina's), Montagehandleiding (16 pagina's), Montagehandleiding (16 pagina's)

Honda CB750 FOUR: Assembly Guide

Stage 10

The front fender

Caution: handle the front

fender with care, as the edges

may be sharp.

Tools

Phillips screwdriver (No. 1)

Cross wrench

Your parts

Front fender stays × 2

Front fender

Caliper holder

Screw (type L)

Screws (type C) × 4

Screws (type K) × 4

Allen key (1.5mm)

Prepare

Front forks (Stage 9)

Front wheel (Stage 3)

Front wheel axle (Stage 9)

Front wheel axle nut (Stage 9)

Screw (type N) × 1 (Stage 9)

Screw (type U) × 1 (Stage 9)

Threading the holes

The holes L3, L4, R3 and R4, circled in blue in these photos, should be tapped prior to

assembly. You should use a type C screw to tap the holes, as it has the correct diameter,

and use the cross wrench received with Stage 9 to screw it in.

Take a type C screw and insert the head into the smallest end of the cross wrench. Press

the projecting end of the screw into one of the blue-circled holes (above) and then turn

the cross wrench as you would a screwdriver. Tighten the screw only about two-thirds

of the way into the hole, and then unscrew it.