Maintronic Sx2 Tuning-Dongle Installatiehandleiding - Pagina 3

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Maintronic Sx2 Tuning-Dongle. Maintronic Sx2 Tuning-Dongle 5 pagina's. For ebike; with bosch active / bosch performace line cablekit sx2kb-perf

Pagina afdrukken

cause an installed SX2 Tuning-Dongle is a modification

or a manipulation of your eBike.

Once the terminals are crimped, the speedsensor plug

(1) should be reconnected to the engine and the chain

applied to the chain wheel.

Now the pedal has to be turned up slowly by hand and

the speedometer should be checked for function. If the

speed is shown on the display repeat the procedure

with a plugged Sx2 Tuning-Dongle into stereo jack so-

cket (5). Until the switch point is reached, the shown

speed jumps to the half speed.

After that, assemble the hood and the e-bike together.

The cablekit should be mounted in a way to protect

the connectors from splashing water and mechanical

damage.

On the following page is a picture of the terminal with a

connected cablekit.

good eBike dealer.

to Control

Unit Intuvia

light-

socket

black

red (+5V)

BOSCH Active Line

BOSCH Performance Line

FAQ

(further Help you can find at support.maintronic.de)

I have done the installation exactly like shown, but the

switchoverpoint is not perceptible?

ANSWER:

Distance and Position of the magnet affecting the

Speed-

sensor

light-

socket

red

black

- Ground

Sx2

switching time of the speed sensor. The shorter the

switching time, the sooner is the switchoverpoint and

conversely. Try to turn up the pedal by hand while the

engine is turned off till 50km/h and watch the speedo-

meter.

If the switchoverpoint is below 12km/h or over 28km/h

or not at all please contact your specialist dealer or the

Sx2 Support >>> [email protected]

How can I influence the switchoverpoint?

ANSWER:

If the speed sensor with the magnet is moved into the

axis direction, the switching speed increase.

Conversely the speed sensor with the magnet is moved

outside to the tire direction, the switching time is shor-

ter and the switching speed is lower.

Manual >>> support.maintronic.de.

Is the cablekit connected correctly?

ANSWER:

Poor contacts may arise fail pulses with the Sx2 Tuning-

Dongle which causing the error 102. Check the tight-

ness of the Sx2 Tuning-Dongle and its contacts.

(Picture with stereo jack socket and measurement de-

vice)

For a further diagnose a bare 3,5mm stereo jack instead

of the Sx2 Tuning-Dongle are plugged. The measure-

ments must be +5V stable between ground(peak) to

ring, the magnet may not stay over the speedsensor.