Majacraft Pioneer Montage-instructies - Pagina 10

Blader online of download pdf Montage-instructies voor {categorie_naam} Majacraft Pioneer. Majacraft Pioneer 11 pagina's.

At this point screw the flyer on to the flyer shaft. It

may help to hold the pulley with your left hand and

tighten the flyer with your right (assuming you are

right handed). It may also be treadled on by holding

the flyer in one hand and treadling the drive wheel in

an anticlockwise direction.

When looking at the wheel from the front (the pedal side), loop

the brake tension band over the top of the bobbin from the right

hand side over to the left hand side.

Firstly slide the bobbin on to the flyer shaft.

It is time to put on the tension knob and spring. Start by sliding

the loop on the tension spring onto the tension knob shaft. Use

the spring loop that does NOT have the brake band attached.

Now slide the tension knob into the hole on the head.

Tie the tension band on to the tension knob shaft

through the small hole in the shaft. We typically

use a reef knot to secure the string. You can now

turn the tension knob to wind the string on to the

shaft until the tension only just takes up. Refer to

the Majacraft Spinning Manual for a more thorough

description on setting the tension.

majacraft