Majacraft Pioneer Instruções de montagem - Página 10
Procurar online ou descarregar pdf Instruções de montagem para Rodas giratórias Majacraft Pioneer. Majacraft Pioneer 11 páginas.
At this point screw the flyer on to the flyer shaft. It
may help to hold the pulley with your left hand and
tighten the flyer with your right (assuming you are
right handed). It may also be treadled on by holding
the flyer in one hand and treadling the drive wheel in
an anticlockwise direction.
When looking at the wheel from the front (the pedal side), loop
the brake tension band over the top of the bobbin from the right
hand side over to the left hand side.
Firstly slide the bobbin on to the flyer shaft.
9b
It is time to put on the tension knob and spring. Start by sliding
the loop on the tension spring onto the tension knob shaft. Use
the spring loop that does NOT have the brake band attached.
Now slide the tension knob into the hole on the head.
9d
Tie the tension band on to the tension knob shaft
through the small hole in the shaft. We typically
use a reef knot to secure the string. You can now
turn the tension knob to wind the string on to the
shaft until the tension only just takes up. Refer to
the Majacraft Spinning Manual for a more thorough
description on setting the tension.
9f
10
9c
9e
majacraft