Gamma 6004 Gebruikershandleiding - Pagina 16

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Gamma 6004. Gamma 6004 20 pagina's. 6 point mounting
Ook voor Gamma 6004: Gebruikershandleiding (20 pagina's), Gebruikershandleiding (20 pagina's), Gebruikershandleiding (19 pagina's)

Pagina afdrukken

MAINTENANCE & ADJUSTMENTS

tight and should be adjusted by turning the Adjustment knob counter clockwise to open the

gap between the jaws. The clamp jaws should be cleaned periodically to be free from dirt, oil,

and any string coating for them to grip properly.

NOTE: Due to the bearings used in the Clamp Lever the action of the Clamp Lever is

very light making it easy to apply excessive clamping pressure. Clamps that are set

too tight can damage the string as well as the string clamp jaws.

String Clamp Adjustment

The string clamps will need minor adjust-

ments according to string type, construction,

and gauge.

To adjust the gap (clamping pressure)

between the clamp jaws, insert the string

through the racquet as if you were beginning

the main strings. Clamp the string and pull

tension. If the string slips through the jaws of

Adjustment

Knob

the clamp, tighten the clamp by compressing

the clamp jaws together by hand while turn-

ing the Adjustment Knob, in the clockwise

direction. If the clamp leaves impressions or

damages the string, it may be excessively

Switch Action Clamp Base Adjust-

ment

If the Switch Action clamp bases slip on the

turntable, the base locking levers may need

adjusted. Turn the hex screw clockwise to

tighten the clamp and counterclockwise to

loosen. If frequent adjustment is needed,

remove the adjustment screw and tighten

the two screws underneath of the clamp.

Re-install the adjustment screw.

Switch Action Clamp Base Removal

If the Switch Action clamp base needs to be

removed, undo the 2 screws holding the FRP

stop, underneath of the turntable. Remove

the FRP stop and clamp for cleaning, adjust-

ment or replacement.