Airflow ACES48ALR Installatie-instructies - Pagina 2

Blader online of download pdf Installatie-instructies voor {categorie_naam} Airflow ACES48ALR. Airflow ACES48ALR 4 pagina's. Ceiling sweep fan

Pagina afdrukken

ACES48ALR

2.0 Fitting the Blades

Discard the plastic spacer as illustrated in the diagram below.

Seat the key-slot holes of the blade on the screws of the fan

motor.

Slide the blade to the right as illustrated, until the blade engages

in the locking mechanism and secure the blade with screws.

Foam

Packaging

Support the motor

Slide blade over screws

3.0 Connecting the Light Fitting

If you are attaching a light ﬁ tting to the fan, do so prior to hanging

the fan.

NOTE:

Clipper Light (CL) and Oyster Light (OL) may be installed in fans

which are constructed for this purpose.

1. Unscrew the plastic nipple from the bottom of the

motor housing

2. Pull out the light wires from the motor housing for connection

with the lamp holder

3. Insert the light wires through the adaptor, then screw the

adaptor into the motor shaft

4. Connect the light wires to the lamp holder then screw the

lamp holder and the adaptor together ﬁ rmly.

Light Wires

2 of 4

Remove plastic spacer

Tighten screws

Light Wires

Plastic Nipple

Adaptor

Lamp Holder

4.0 Hanging the Fan

Hangsure Bracket

Position the ball-joint in the bracket so that the guide pin on the

bracket engages in the slot in the ball-joint.

Guide Pin

5.0 Installing the Fan

Ceiling Sweep Fan Installation Instructions

Slot

Lift the fan up and place the

nylon ball onto the bracket.

Make sure the guide pin of

bracket is ﬁ tted into slot of

ball-joint.

1. Install the receiver to the

bracket as shown. Connect

the wires according to the

remote control wiring

instructions (page 3)

2. Loosen the screw in the

sensor bracket, insert the

infrared sensor into the hole

on the canopy. Ensure the

infrared sensor is held by

the metal plate as shown

and tighten the screw

3. Manoeuvre the canopy

into place over the mounting

bracket. Ensure that the

infrared sensor is in the

shade and not in direct

sunlight. Slide up top

cowl but allow 5-10mm

clearance. Secure with

locking screws.