IKEA EVENTUELL Installatie-instructies en gebruiks- en onderhoudshandleiding - Pagina 9
Blader online of download pdf Installatie-instructies en gebruiks- en onderhoudshandleiding voor {categorie_naam} IKEA EVENTUELL. IKEA EVENTUELL 48 pagina's. 30" (76.2 cm) range hood liner
Pagina afdrukken
It is recommended that the vent system be installed before
the range hood is installed.
Before making cutouts, make sure there is proper clearance
within the ceiling or wall for vent fittings.
Making the cutout to the bottom of the cabinet may be easier
to do prior to mounting the cabinet to the wall.
1. Disconnect power.
2. Determine which venting method to use: roof, wall, or non-
vented.
3. Select a flat surface for assembling the range hood. Place
covering over that surface.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
range hood.
Failure to do so can result in back or other injury.
4. Using 2 or more people, lift range hood onto covered surface.
Range Hood Cabinet Cutout
IKEA SEKTION Type Cabinets
1. Assemble the IKEA SEKTION cabinet using assembly
instructions that come with the cabinet with the exception:
"Do not assemble the bottom panel or the doors."
2. Use the instructions included with the IKEA SEKTION cabinet
to install the assembled cabinet to the wall.
3. Install the cabinet filler strip (supplied with range hood). Align
the cabinet filler strip flush with the bottom and front face of
the cabinet. Mark and drill ¹⁄₈" (3 mm) pilot holes in 2 places
on each end. Secure the cabinet filler strip to the inside of the
cabinet using four 4.5 x 13 mm #2 Phillips wood screws.
A
A
A. Screws - 4.5 x 13 mm (#2 Phillips) (4)
B. Cabinet filler strip (supplied)
4. Assemble the cabinet doors to the cabinet using the
instructions that come with the door hinges.
NOTE: Align the cabinet doors, if necessary, using the
instructions that come with the door hinges.
INSTALLATION INSTRUCTIONS
Prepare Location
A
A
B
5. Remove the cabinet doors from the door hinge clips that are
mounted to the inside of the cabinet according to the
instructions that come with the door hinges.
6. Locate side mounting bracket flush to the bottom of the
cabinet side and against the inside of the front of the cabinet
filler strip. Orient the bracket as shown in the following
illustration. Drill ¹⁄₈" (3 mm) pilot holes in 8 places, attach a
bracket using four 4.5 x 13 mm #2 Phillips screws to each
side of the cabinet, and tighten.
Bracket Orientation for 30" (76.2 cm) Cabinet
B
A
A. 30" (76.2 cm) cabinet
B. Screws - 4.5 x 13 mm #2 Phillips (8)
C. Metal washers (optional)
D. Mounting bracket (2) (position for 30" [76.2 cm] cabinet)
Frame Type Cabinets 12" (30.5 cm) depth
1. Use a saber saw or keyhole saw to cut out the cabinet
bottom inside the cabinet frame.
A. Bottom of cabinet cutout
B. Bottom must be cut flush to the inside walls of the cabinet.
⁷⁄₈
"
C. 10
(27.6 cm) min. from the inside of the cabinet front face
³⁄₄
D.
" (1.9 cm) thick front face required for cabinet bottom.
E. Front of cabinet
C
D
E
D
A
C
B
9