Alibi Security Vigilant ALI-SB50-UZ Snelstarthandleiding - Pagina 2

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Alibi Security Vigilant ALI-SB50-UZ. Alibi Security Vigilant ALI-SB50-UZ 2 pagina's. Specialty ip camera

Pagina afdrukken

Setup - Video setting

Installation

Setup - Video setting

Installation

This Network camera supports triple streams simultaneously

Stream selection

Event - Alarm and Motion

Alarm In / Out Setting

RTSP address

Video settings for streams

Motion detection Setting

Setup - System

Alibi Vigilant Recorder Note:

These IPC will not Plug and Play with Vigilant NVRs. In order to plug IPC into

back of NVR you must set up the camera to match the NVRs internal NIC

address (i.e. 172.16.0.XXX), then plug into NVR.

To attach IPC to back of NVR:

1.) Plug IPC into POE switch or regular switch with a 12v power supply

attached to camera.

2.) Log into camera via default IP address (192.168.1.30) through web

browser.

3.) Go to Setup -> Basic Configuration -> Network

4.) Change IP address to match internal NIC scheme of NVR, match the subnet

mask (255.255.0.0 is default), set the default gateway.

5.) Click Save at the bottom.

6.) Unplug IPC from switch and plug into desired channel on back of NVR

7.) Log into NVR and go to Menu -> Camera

8.) Within the row of the channel you'd like to add camera, click on the Cam

Config icon

9.) Change Add Mode to IP Address, Protocol to ONVIF, IP address of IPC,

HTTP Port (default 80), username, password.

10.) Click OK.

Notes:

Vigilant NVR will not find the IPC on network via Auto Search option.

Motion detection is supported, however the motion detection field needs to

be set up within the IPC web GUI (Section 6 of instructions). The NVR will not

allow you to edit the motion detection field or sensitivity with in the NVR ->

Menu -> Alarm -> Motion settings.

Update F/W

Factory set & Reset

Expert all parameters for device and

user defined scripts

Update configuration file

Event -