KitchenAid KGBS 146S Handleiding voor installatie-instructies - Pagina 2

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} KitchenAid KGBS 146S. KitchenAid KGBS 146S 11 pagina's. Gas built-in single & double ovens

Pagina afdrukken

IMPORTANT:

Read

Before

Installing

to Save

Time,

Work,

assure

proper

performance,

and

owner's

warranty

protection.

INSTALLATION

INSTRUCTIONS

The oven installation

must conform with local codes and ordinances

and ulility regulations.

In the absence of local

codes, installation

must conform with American

National Standard, National Fuel Gas Code ANSI Z223.1-latest

edition. It is the customer's responsibility

to contact a qualified electrical installer to assure that electrical installation

is adequate and in conformance

with National Electrical Code, ANSVNFPA 70-latest edition and local codes and

ordinances.

When installed in a mobile home, the installation

must conform to the Manufactured

Home Construction

and Safety

Standards, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile Home Construction

and Safety, Title

24, HUD, Part 280).

Fire Hazard

Do Not use or store gasoline, paint, thinners and other flammable materials

near oven.

Do Not obstruct the flow of combustion

and ventilation air.

If you smell gas:

1. Open windows.

2. Don't touch electrical switches.

3. Extinguish any open flame.

4. Immediately call your gas supplier.

Failure to follow these instructions

could result in a fire or explosion.

CABINET CONSTRUCTION

The cabinet must have either a solid bottom or two runners,l9-l/2

inches apart, and centered

within the cabinet.

The bottom or

runners must be able to support the weight of the unit (225 pounds

Oven Gas

for a double oven). The bottom or runners must be level and straight

Inlet 3/s NPT

Male

and flush with the cabinet cutout. The oven must be level for proper

baking. Once installed the oven cannot be leveled.

Note: Clearances specified are for combustible

walls and materi-

als that have a density of 20 or more pounds per cubic foot. No

evaluation of clearances

has been made for installations

adjacent

to materials that are less than 20 pounds per cu. ft. or to plastictiles

and sheeting.

The inlet for the gas supply line and opening

for the electric

supply cord are located at the rear under the unit as shown

at right.

Electric Supply

Cord Inlet

to Oven

Cabinet

Damage Hazard

Not block

the oven vent.

Blocking

the vent may cause

cabinet

damage and poor baking performance.

FRONT OF CABlNET