Gardena 8000/4 4T Gebruiksaanwijzing - Pagina 3
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Gardena 8000/4 4T. Gardena 8000/4 4T 8 pagina's. Petrol-driven motor pump
Pagina afdrukken
3. Putting Into Operation
v Position the pump at a safe distance from the liquid to be
pumped.
Connect the suction hose :
The suction connection is equipped with a 33.3 mm (G 1) thread.
A vacuum-resistant suction hose must be screwed airtight onto
the suction side of the pump. Do not use garden hose connec-
tion system fittings
• e. g. GARDENA Suction Hose Art. No. 1412
2
v Screw the vacuum-resistant suction hose
connection
To avoid blockages or damaging the turbine we recommend con-
necting a suction unit with suction filter between the hose and the
suction connection.
1
• e. g. GARDENA Suction Unit with backflow preventer
Art. No. 1411 / 1418
Connect the delivery hose :
The delivery connection of the pump is fitted with a 33.3 mm
(G 1) thread to which you can connect 13 mm (1/2"), 15 mm
3
4
(5/8") or 19 mm (3/4") hoses using the GARDENA hose con-
nection system fittings.
v Connect the delivery hose
of the pump.
For the best delivery capacity, connect 19 mm (3 /4") hoses to-
gether with GARDENA "Profi" System Fittings (e.g. Art. 1752)
or 25 mm (1") hoses together with GARDENA Brass Connection
Fittings (e.g. Art. 7142).
Connecting several
When connecting several hoses or accessories in parallel we
recommend using the GARDENA Twin-Tap Connector or Four
pressure hoses in parallel :
Channel Water Distributor Art. 1210 / 1194.
v Screw the Twin-Tap Connector or Four Channel Water Distri-
butor directly onto the thread of the delivery connection
4. Operation
Check the motor :
1. Set up the pump with the motor turned off.
2. Check the oil level (see 5. Maintenance).
3. Check the petrol level (see 5. Maintenance).
4. Check the air filter (see 5. Maintenance).
16
1
onto the suction
2
of the pump and ensure it is airtight.
3
4
to the delivery connection
4
Fill the pump with the liquid
to be pumped :
5
6
Start the motor :
7
closed
open
8
slow
.
9
A
Fill the pump with approx. 1.5 litres of the liquid to be pumped
before operating the pump.
5
1. Unscrew the cover
from the filler neck
to be pumped.
2. Fill the pump chamber completely by pouring the liquid to
6
be pumped into the filler neck
(approx. 1.5 litres).
5
3. Replace the cover
on the filler neck
by hand.
V Before starting the motor, always inspect the motor and
fill the pump with the liquid to be pumped.
1. If the motor is cold, push the choke lever
(closed).
If the motor is warm, push the choke lever
(open).
8
2. Move the throttle lever
to the middle position between
slow
and
fast.
3. If the motor is cold or if you have just filled the tank with petrol
9
press the starter ball pump
repeatedly until you can see
petrol in the transparent petrol hose
0
A
4. Turn the ignition switch
to „I" (ON).
6
for the liquid
6
and screw tight
7
up to position
7
down to position
0
.
17