8
4
c
2
5
5. Operation
Connect extension cable :
0
A
1
2
7
Starting Aerator :
3
C
B
16
7
2. Insert the two locking bolts
in the two central sections
lower sections of the upright
3
3. Screw the upper part of the upright with starting handle
the central sections of the upright
1
bolts
1
This completes the assembly of the hanle.
Warning : Fit the upper section of the upright with starting
handle
6
cable
(see fig.).
4. Attach connection cable
9
c
clips
1. Push connector of extension cable
2. Draw a loop of the extension cable
relief device
This prevents inadvertent disconnection of the plug and socket
connection.
3. Insert extension cable
Danger of injury if the Aerator does not switch off auto-
matically !
V Do not remove or bridge safety devices fitted to the
Aerator (e.g. by tying the starting lever to the upper
handle) !
DANGER ! The Aerator does not stop immediately
A
after the motor has been switched off :
V Never lift, tip or carry the Aerator with the motor
V Never start on solid ground (e.g. asphalt).
V Always maintain the safety distance between the
1. Place Aerator on flat grass surface.
2. Keep safety interlock
on the upper handle
3. Release safety interlock
When in operation, the extension cable
guided in the direction you are working and to the side of
the area to be worked on.
Always work away from the connection cable.
1
2
4
and the wing nuts
3
in such a way that the plug
8
is on the right side (in direction of movement)
8
to the handle with the two cable
.
A
1 and suspend in position 2.
0
into a mains socket.
running !
aerator cylinder and the user as defined by the
guide handle.
B
pressed down and pull starting lever
3
. The Aerator starts.
B
.
from outside through the holes
of the upright and secure to the
5
4
with two wing nuts
2
with two more locking
.
7
with the power
0
on to the plug
0
through the cable strain
0
must always be
.
3
to
7
.
C
Pagina afdrukken