Gardena 4068 Інструкція з експлуатації Посібник з експлуатації - Сторінка 6

Друкувати сторінку

Gardena 4068 Інструкція з експлуатації Посібник з експлуатації

5. Operation

Connect extension cable :

Starting Aerator :

2. Insert the two locking bolts

in the two central sections

lower sections of the upright

3. Screw the upper part of the upright with starting handle

the central sections of the upright

bolts

This completes the assembly of the hanle.

Warning : Fit the upper section of the upright with starting

handle

cable

(see fig.).

4. Attach connection cable

clips

1. Push connector of extension cable

2. Draw a loop of the extension cable

relief device

This prevents inadvertent disconnection of the plug and socket

connection.

3. Insert extension cable

Danger of injury if the Aerator does not switch off auto-

matically !

V Do not remove or bridge safety devices fitted to the

Aerator (e.g. by tying the starting lever to the upper

handle) !

DANGER ! The Aerator does not stop immediately

after the motor has been switched off :

V Never lift, tip or carry the Aerator with the motor

V Never start on solid ground (e.g. asphalt).

V Always maintain the safety distance between the

1. Place Aerator on flat grass surface.

2. Keep safety interlock

on the upper handle

3. Release safety interlock

When in operation, the extension cable

guided in the direction you are working and to the side of

the area to be worked on.

Always work away from the connection cable.

and the wing nuts

in such a way that the plug

is on the right side (in direction of movement)

to the handle with the two cable

1 and suspend in position 2.

into a mains socket.

running !

aerator cylinder and the user as defined by the

guide handle.

pressed down and pull starting lever

. The Aerator starts.

from outside through the holes

of the upright and secure to the

with two wing nuts

with two more locking

with the power

on to the plug

through the cable strain

must always be