Gardena ErgoJet 3000 Gebruiksaanwijzing - Pagina 12

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Gardena ErgoJet 3000. Gardena ErgoJet 3000 18 pagina's. Electric blower/vac
Ook voor Gardena ErgoJet 3000: Handmatig (10 pagina's), Gebruiksaanwijzing (19 pagina's), Gebruiksaanwijzing (19 pagina's), Gebruiksaanwijzing (17 pagina's), Gebruiksaanwijzing (10 pagina's), Gebruikershandleiding (8 pagina's)

Pagina afdrukken

WARNING:

extension cord. Wait until the impeller has completely stopped turning,

then remove the vacuum tubes. Carefully reach into the vacuum opening

and clear out the clogged debris.

This will reduce possible personal injury from the impeller.

Removing an object from the

air intake:

7. Troubleshooting

WARNING:

performing all of the recommended remedies below except remedies

that require unit to be operating.

The motor must be stopped and the impeller blades no longer turning to

avoid serious injury from the rotating blades.

Problem

Unit fails to operate.

Unit vibrates abnormally.

Impeller will not

turn freely.

For any other malfunctions, please contact the GARDENA

service department. Repairs must be carried out by GARDENA

service departments or specialist dealers authorised by

GARDENA.

If the unit becomes clogged, stop the unit and unplug the

1. Remove the vacuum tubes.

2. Carefully reach into the vacuum opening and clear out the air

intake area. Clear all debris from impeller.

3. Inspect the impeller for cracks. If cracked or damaged,

do not use the unit. Have parts replaced by your authorized

service dealer. Do not attempt to replace them yourself.

Always stop unit and unplug the extension cord before

Possible cause

1. Switch in the OFF (0) position.

2. Extension cord disconnected.

3. Circuit breaker tripped,

or fuse blown.

4. Blower tube, elbow tube,

and/or vacuum tube not

installed correctly.

5. Collection bag is full.

6. Mechanical failure.

1. Mechanical failure.

1. Debris in air intake area.

2. Mechanical failure.

Remedy

1. Slide switch to

ON (I) position.

2. Reconnect extension cord.

3. Reset circuit breaker or

fuse.

4.Check tube installation.

5. Empty collection bag.

6. Contact your authorized

service dealer.

1. Contact your authorized

service dealer.

1. Clean unit. Remove any

debris.

2. Contact your authorized

service dealer.