Gardena ErgoJet 3000 사용 설명서 - 페이지 12
{카테고리_이름} Gardena ErgoJet 3000에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena ErgoJet 3000 18 페이지. Electric blower/vac
Gardena ErgoJet 3000에 대해서도 마찬가지입니다: 매뉴얼 (10 페이지), 사용 설명서 (19 페이지), 사용 설명서 (19 페이지), 사용 설명서 (17 페이지), 사용 설명서 (10 페이지), 운영자 매뉴얼 (8 페이지)
페이지 인쇄
WARNING:
extension cord. Wait until the impeller has completely stopped turning,
then remove the vacuum tubes. Carefully reach into the vacuum opening
and clear out the clogged debris.
This will reduce possible personal injury from the impeller.
Removing an object from the
air intake:
7. Troubleshooting
WARNING:
performing all of the recommended remedies below except remedies
that require unit to be operating.
The motor must be stopped and the impeller blades no longer turning to
avoid serious injury from the rotating blades.
Problem
Unit fails to operate.
Unit vibrates abnormally.
Impeller will not
turn freely.
For any other malfunctions, please contact the GARDENA
service department. Repairs must be carried out by GARDENA
service departments or specialist dealers authorised by
GARDENA.
26
If the unit becomes clogged, stop the unit and unplug the
1. Remove the vacuum tubes.
2. Carefully reach into the vacuum opening and clear out the air
intake area. Clear all debris from impeller.
3. Inspect the impeller for cracks. If cracked or damaged,
do not use the unit. Have parts replaced by your authorized
service dealer. Do not attempt to replace them yourself.
Always stop unit and unplug the extension cord before
Possible cause
1. Switch in the OFF (0) position.
2. Extension cord disconnected.
3. Circuit breaker tripped,
or fuse blown.
4. Blower tube, elbow tube,
and/or vacuum tube not
installed correctly.
5. Collection bag is full.
6. Mechanical failure.
1. Mechanical failure.
1. Debris in air intake area.
2. Mechanical failure.
Remedy
1. Slide switch to
ON (I) position.
2. Reconnect extension cord.
3. Reset circuit breaker or
fuse.
4.Check tube installation.
5. Empty collection bag.
6. Contact your authorized
service dealer.
1. Contact your authorized
service dealer.
1. Clean unit. Remove any
debris.
2. Contact your authorized
service dealer.