Garmin TR-1 Gold Gebruikershandleiding - Pagina 28

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Garmin TR-1 Gold. Garmin TR-1 Gold 38 pagina's. Throttle actuator
Ook voor Garmin TR-1 Gold: Basishandleiding (9 pagina's), Snelle referentie (2 pagina's), Montage-instructies (7 pagina's), Installatie-instructies (4 pagina's), Eigenaar Handheld Snelle referentie (2 pagina's)

When you select special functions, by the methods described below, you are simply choosing which

function is to be executed by the pilot when you push one of the tree special function buttons.

The Idle/Resume button is programmable to provide either Idle/Resume or MOB or Zigzags (other).

The Bent Left Arrow button is programmable to provide either Steps or Circles or Remote Steer.

The Bent Right Arrow is used to program the pilot for waypoint Orbiting or clover leaf or search

steering in conjunction with your GPS.

To change the functions of these programmable buttons, follow the directions below.

1. Autopilot must be in Heading Hold or Standby Mode before selection process can start.

(AUTO LED solid on or STBY LED solid on. No other LED's on.)

2. Press and hold Setup Button. Three LED's next to the numbers 1 through 9 will illuminated,

indicating which (3) special functions are programmed to operate. For example, if LED 2, 4, and 7

illuminate, your system is programmed to do: 1) Idle Resume when the Idle/Resume button is

pressed. 2) Step turns to port when the Left Bent Arrow button is pressed. 3) Step Turns to

starboard when the Bent Right Arrow button is pressed. 4) Orbit a waypoint clockwise when the

Bent Right Arrow button is pressed and the system is tracking a GPS signal. 5) Orbit a waypoint

clunterclockwise when the Bent Left Arrow button is pressed and the system is tracking a GPS

signal.

3. Select the Special Function you want to use by pressing and releasing the Idle/Resume and Left

Bent Arrow button until the appropriate LED's are lit. (See the Table below for Special Function

Indicators.)

4. Release the Setup Button.

5. To make the selected Special Functions into start up defaults: Press and release the Setup

button and verify the setup LED is lit. Then press and hold the GPS (Select Load) button. Verify

that the Load LED is lit. Then press and release the Deckmount switch, then release the GPS (Select

Load button). (This Locks in your selections)

6. To illuminate the keypad on the remote for nighttime operation: Press and hold setup and press

the up arrow. Repeat to turn the back light off. The down arrow will toggle the brightness of the

orange LEDs between bright and dim when the setup button is held down.

Special Function Indicator LED Numbers

MOB

Idle/Resume

Other

Selecting Special Functions

Steps

Circles

Remote Steer

GPS Steering

(GPS connection required)

Orbit Wpt.

3 Leaf Clover