Fujitsu ETERNUS DX60 Configuratiehandleiding - Pagina 14

Blader online of download pdf Configuratiehandleiding voor {categorie_naam} Fujitsu ETERNUS DX60. Fujitsu ETERNUS DX60 16 pagina's. Disk storage system
Ook voor Fujitsu ETERNUS DX60: Installatiehandleiding (4 pagina's), Gebruikershandleiding (35 pagina's), Gebruikershandleiding (42 pagina's), Installatiehandleiding (4 pagina's), Optionele producten gebruiken (2 pagina's), Configuratiehandleiding (28 pagina's), Optionele producten gebruiken (2 pagina's), Product Introductie (19 pagina's), Inhoud verpakking (4 pagina's), Handmatig (4 pagina's)

Chapter 2

Setting Up the ETERNUS DX

2.3

*2: When multiple ESX servers share ETERNUS DX LUNs, any ETERNUS DX CA port that connects a shared

LUN to an ESX server must be assigned to the same reset group, whether multi-paths are used for the

ESX servers or not.

Example: When multiple ESX servers share ETERNUS DX LUNs, CM#0 CA#0 Port#1 and CM#1 CA#0 Port#1

must be assigned to the same reset group, even for single-path configurations.

LAN switch#1

2.2.2

Setting the Subsystem Parameters (for HP-UX only)

Disable the [Load Balance] parameter in "Set Subsystem Parameters" screen. This prevents sense responses

that require access retries from being issued when the ETERNUS DX is overloaded.

For HP-UX server, improper logs may be recorded unless sense response is restricted. Therefore, "Load Bal-

ance" should be disabled. (Sense response should be restricted.)

Note that changing the "Load Balance" setting has no affect on non-HP-UX servers.

2.3

Checking the WWNs

Use ETERNUS Web GUI to check the WWN of each ETERNUS DX. They are required for connecting the ETERNUS

DX to the server.

Server#1

HBA#1

CM#0

Port#1

Affinity-Group

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-

Server#2

HBA#1

LAN switch#2

CM#1

Port#1

P3AM-3182-15ENZ0