Fujitsu ETERNUS DX60 Руководство по конфигурации - Страница 14

Просмотреть онлайн или скачать pdf Руководство по конфигурации для Хранение Fujitsu ETERNUS DX60. Fujitsu ETERNUS DX60 16 страниц. Disk storage system
Также для Fujitsu ETERNUS DX60: Руководство по настройке (4 страниц), Руководство пользователя (35 страниц), Руководство пользователя (42 страниц), Руководство по настройке (4 страниц), Использование дополнительных продуктов (2 страниц), Руководство по конфигурации (28 страниц), Использование дополнительных продуктов (2 страниц), Введение продукта (19 страниц), Содержание пакета (4 страниц), Руководство (4 страниц)

Печатать страницу
Fujitsu ETERNUS DX60 Руководство по конфигурации
Chapter 2
Setting Up the ETERNUS DX
2.3

Checking the WWNs

*2: When multiple ESX servers share ETERNUS DX LUNs, any ETERNUS DX CA port that connects a shared
LUN to an ESX server must be assigned to the same reset group, whether multi-paths are used for the
ESX servers or not.
Example: When multiple ESX servers share ETERNUS DX LUNs, CM#0 CA#0 Port#1 and CM#1 CA#0 Port#1
must be assigned to the same reset group, even for single-path configurations.
LAN switch#1
2.2.2

Setting the Subsystem Parameters (for HP-UX only)

Disable the [Load Balance] parameter in "Set Subsystem Parameters" screen. This prevents sense responses
that require access retries from being issued when the ETERNUS DX is overloaded.
For HP-UX server, improper logs may be recorded unless sense response is restricted. Therefore, "Load Bal-
ance" should be disabled. (Sense response should be restricted.)
Note that changing the "Load Balance" setting has no affect on non-HP-UX servers.
2.3
Checking the WWNs
Use ETERNUS Web GUI to check the WWN of each ETERNUS DX. They are required for connecting the ETERNUS
DX to the server.
Server#1
HBA#1
CM#0
Port#1
Affinity-Group
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-
Copyright 2015 FUJITSU LIMITED
Server#2
HBA#1
LAN switch#2
CM#1
Port#1
14
P3AM-3182-15ENZ0