Brother 2 Handmatig - Pagina 10
Blader online of download pdf Handmatig voor {categorie_naam} Brother 2. Brother 2 39 pagina's. Hewlett-packard laser printer user guide
Ook voor Brother 2: Gebruikershandleiding (15 pagina's)
Pagina afdrukken
Installing the Roll Feeder
In order to install the roll feeder for cutting, the cutting machine must be prepared, and preparations must be made to install the roll
feeder and rolled material onto the machine.
Check that the software version on the cutting machine is Ver. 1.60 or later before attaching the roll feeder. If the version is older
than Ver. 1.60, update the software.
Installing the Base Attachment to the Machine
• You can also view a video of the installation of the roll feeder.
http://s.brother/cvsae/
a
Touch
in the home screen to display the following
screen.
Memo
• When using the roll feeder, "Retrieve Data" and "Test" are
not available. Select "Roll Feeder" to use those functions.
(page 16 and page 19)
• When using the roll feeder, "Scan" is not available.
b
Select "Roll Feeder".
Memo
• After "Roll Feeder" is selected, the following screen
appears. Select "Attach the roll feeder" to confirm the
instructions for installing the roll feeder.
c
Pull the feeder release lever (on the right side of the
machine) toward you.
a Feeder release lever
Only the right side of the shaft is raised, and the shaft is
unlocked.
d
Grab the feed roller and feed roller lock dial, and then,
while holding the feed roller in place, rotate the feed
roller lock dial toward the back to the unlock position
(
).
The feed roller can be slid.
1 2
a Feed roller
b Feed roller lock dial
e
Slide the feed roller from
a Feed roller
1
to
.
1
9