Indesit Arcadia Gebruikershandleiding - Pagina 3

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Indesit Arcadia. Indesit Arcadia 3 pagina's. Fault codes

Pagina afdrukken

FAULT

NTC dryer sensor open / short-circuiting. Fan

F13

Motor jammed. Condenser or blower clogged

Triac+dryer heating element short-circuit / dryer

heating element leakage on thermofuse side /

dryer heating element interrupted / diverter

relay sticking on wash heating element side

F15

/ dryer heating element pin feedback in short-

circuit with Vdc / Pump not wired / short-circuit

of triac driving pump / diverter relay sticking on

wash heating element side / drain pump pin

feedback in short-circuit with Vdc / Prewash

solenoid valve not wired.

F16

Drum locking (top-loading only)

No UART communication between DSP and

F18

Main

Fan motor not wired / Fan motor driving triac

short circuit or Switch relay contacts

F19

sticking / Fan motor pin feedback in shot

circuit with Vcc

3/3

Arcadia Fault Codes (Simple)

CAUSE

- Check the condenser ﬁ lter is not clogged;

- Check there is no ﬂ uff in the blower fan;

If the components are clean or the problem persists despite

cleaning, then:

- Check the efﬁ ciency of the connector contacts of the NTC on

- Check the impedance value of the NTC on the relevant connector

- If measurement is incorrect, check NTC wiring;

- Check the same parameter (20kΩ) directly on the NTC.

- Replace the NTC;

- Replace the main PCB.

- Check the connector of the dryer heating element (1500W /

- Check leakage between the two ends and ground, impedance

- Check efﬁ ciency of Drain Pump contacts on PCB;

- Check continuity of Drain Pump on connector (pins 4 and 5 in

- Check the drain pump wiring;

- Check the Solenoid Valve connectors and wiring;

- Replace the drain pump;

- Replace the dryer heating element;

- Replace the damaged solenoid valve;

- Replace the main PCB.

- Check for 220 V power at the lock;

- Check the connectors;

- Check continuity of wiring;

- Replace PCB.

- Disconnect appliance for 2 minutes. Check that correct operation

- If fault reappears renew main PCB.

- Check efﬁ ciency of connector and wiring continuity on the blower

- Check efﬁ ciency of connector and wiring continuity on the heating

- Check fan motor is not in short circuit or open circuit;

- Check fan motor turns freely (it is not blocked partially);

- Replace the main PCB.

Note: Faults F04 and F10 are not present

SERVICE ACTIONS

the main PCB;

(next to Main PCB) between pin 1 and pin 2. The impedance

value at ambient temperature (20°C) must be approximately

20kΩ;

Check efﬁ ciency of relative contacts on the connector on PCB

side;

230V), ensuring between pins 1 and 2 that the impedance value

is approximately 36 Ω;

should be at least 2 MΩ;

case of classic door lock), ensuring that impedance value is 170

Ω +/- 10%;

has been restored by starting the Autotest routine;

fan;

element of the blower;