Indesit SIXL145DUK Service Informatie Handleiding - Pagina 22

Blader online of download pdf Service Informatie Handleiding voor {categorie_naam} Indesit SIXL145DUK. Indesit SIXL145DUK 28 pagina's. Moon washing machines

Pagina afdrukken

Indesit

Company

Fault indication LEDs flash together with programme button LEDs

FAULT

CAUSE

F01

Motor triac short circuit

LED 1

F02

Motor jammed, motor tacho

generator open or short

LED 2

circuit.

F03

NTC wash thermistor open /

short circuit or wash heating

element relay contacts

LEDs

sticking (signalled at time of

1 & 2

full tub).

F04

Pressure switch stuck on

empty.

LED 3

F05

Machine will not empty or

pressure switch stuck in full

LEDs

position.

1 & 3

F07

Heater relay stuck or element

LEDs

open circuit.

1, 2 &

3 ON

Service Manual UK

CORRECTIVE ACTIONS

Check for continuity of motor (Field coil pins 3-5 and

armature pins 1-2);

Check efficiency of module connector block J9, motor

terminal block and wiring between motor and edge

connector J9;

Check motor not seized;

Check edge connector J9 has secure connections on

module;

Remove edge connector J9 on module check wiring and

contacts at position 1 and 2 on connector J9;

Check tacho generator windings and that there is an

impedance value of between 115 and 170 Ω on the wiring

connector J9 between pins 1 and 2;

Check edge connector J8 has secure connections on

module;

Check thermistor and wiring;

Remove edge connector J8 from module check wiring at

position 11 and 12 on connector J8;

Remove plug from thermistor. The resistance at room

temperature (20°C) is approximately 20KΩ.

Machine continually fills until it reaches overfill safety level.

Drain pump is then started by overflow contacts in pressure

switch;

Check edge connector J3 has secure connections on

module;

Check pressure switch connections;

Check wiring connections are secure between pressure

switch and edge connector J3 on module;

Check pump is not jammed or faulty;

Check edge connector J9 has secure connections on

module and drain pump;

This fault is only signalled when pressure switch is in the

empty position;

Check edge connector J3 has secure connections on

module;

Check wiring to heater and continuity of wash element

(25Ω);

Check pressure switch connections and correct pressure

switch operation;

22 of 28

English