Indesit SIXL145DUK Інформаційний посібник з обслуговування - Сторінка 22

Переглянути онлайн або завантажити pdf Інформаційний посібник з обслуговування для Пральна машина Indesit SIXL145DUK. Indesit SIXL145DUK 28 сторінок. Moon washing machines

Друкувати сторінку

Indesit

Company

Fault indication LEDs flash together with programme button LEDs

FAULT

CAUSE

F01

Motor triac short circuit

LED 1

F02

Motor jammed, motor tacho

generator open or short

LED 2

circuit.

F03

NTC wash thermistor open /

short circuit or wash heating

element relay contacts

LEDs

sticking (signalled at time of

1 & 2

full tub).

F04

Pressure switch stuck on

empty.

LED 3

F05

Machine will not empty or

pressure switch stuck in full

LEDs

position.

1 & 3

F07

Heater relay stuck or element

LEDs

open circuit.

1, 2 &

3 ON

Service Manual UK

CORRECTIVE ACTIONS

Check for continuity of motor (Field coil pins 3-5 and

armature pins 1-2);

Check efficiency of module connector block J9, motor

terminal block and wiring between motor and edge

connector J9;

Check motor not seized;

Check edge connector J9 has secure connections on

module;

Remove edge connector J9 on module check wiring and

contacts at position 1 and 2 on connector J9;

Check tacho generator windings and that there is an

impedance value of between 115 and 170 Ω on the wiring

connector J9 between pins 1 and 2;

Check edge connector J8 has secure connections on

module;

Check thermistor and wiring;

Remove edge connector J8 from module check wiring at

position 11 and 12 on connector J8;

Remove plug from thermistor. The resistance at room

temperature (20°C) is approximately 20KΩ.

Machine continually fills until it reaches overfill safety level.

Drain pump is then started by overflow contacts in pressure

switch;

Check edge connector J3 has secure connections on

module;

Check pressure switch connections;

Check wiring connections are secure between pressure

switch and edge connector J3 on module;

Check pump is not jammed or faulty;

Check edge connector J9 has secure connections on

module and drain pump;

This fault is only signalled when pressure switch is in the

empty position;

Check edge connector J3 has secure connections on

module;

Check wiring to heater and continuity of wash element

(25Ω);

Check pressure switch connections and correct pressure

switch operation;

22 of 28

English