Indesit BAAN 40 FNF WD xx (TK) Gebruiksaanwijzing - Pagina 6

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Indesit BAAN 40 FNF WD xx (TK). Indesit BAAN 40 FNF WD xx (TK) 16 pagina's. Refrigerator/freezer combination
Ook voor Indesit BAAN 40 FNF WD xx (TK): Gebruiksaanwijzing (16 pagina's)

Pagina afdrukken

WATER DISPENSER

Filling the water tank.

- Use natural water only.

- Do not use other beverages such as milk, fruit juices,

alcoholic beverages or fizzy drinks.

- Fill the tank up the MAX level indicated.

- PET bottles cannot be used.

1 Remove the cover and fill the tank with water up to the MAX

level indicated.

This operation must be carried out only once the tank is

mounted on the door.

1 The tank can contain 3 l of water.

2 Fill with natural water only.

3 Do not leave the water in the tank for long periods or when

the HOLIDAY function is activated.

Cleaning the water tank.

1 Ensure that the tank is completely empty before removing it.

2 Clean all the elements with a clean cloth, using water only.

3 Do not use detergents or other chemical products.

4 Do not wash in the dishwasher.

5 Before putting the tank back in place, ensure that the seals

are correctly placed.

6 After water is discharged, any leaking drops are collected in

the tray located beneath the removable grille.

Child safety

The device is equipped with a safety system: when engaged, it

prevents children from discharging water from the appliance.

To activate the "Child Safety" system, move the lever to "Lock"

as indicated in the picture.

To deactivate the system, move the lever back into the initial

"Unlock" position.

Unlock

Lock

Freezer compartment

ICE CARE tray

The fact that they are situated on the top part of the freezer

drawers ensures greater cleanliness: the ice no longer

comes into contact with the food placed inside the freezer

compartment; furthermore, the dripping of the water during

filling is avoided (a lid to cover up the hole after filling with

water is also provided).

1. Pull out the tray by pushing it up.

Check that the tray is ompletely empty and fill it with water

through the opening provided.

2. Take care not to exceed the level indicated (MAX WATER

LEVEL). Excess water prevents the ice cubes from

dispensing (if this happens, wait for the ice to melt and

empty the tray).

3. Turn the tray 90°: due to the connected compartments each

mould fills with water (see diagram).

4. Close the opening with the lid provided and put the tray

back.

5. When the ice has formed (minimum time approximately 8

hours) knock the tray against a hard surface and wet the

outside so that the ice cubes come loose and take them out

through the opening.

MAX

WATER LEVEL