Indesit BAAN 40 FNF WD xx (TK) Instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Lodówka Indesit BAAN 40 FNF WD xx (TK). Indesit BAAN 40 FNF WD xx (TK) 16 stron. Refrigerator/freezer combination
Również dla Indesit BAAN 40 FNF WD xx (TK): Instrukcja obsługi (16 strony)
Drukuj stronęGB
WATER DISPENSER
Filling the water tank.
- Use natural water only.
- Do not use other beverages such as milk, fruit juices,
alcoholic beverages or fizzy drinks.
- Fill the tank up the MAX level indicated.
- PET bottles cannot be used.
1 Remove the cover and fill the tank with water up to the MAX
level indicated.
This operation must be carried out only once the tank is
mounted on the door.
2
1
1 The tank can contain 3 l of water.
2 Fill with natural water only.
3 Do not leave the water in the tank for long periods or when
the HOLIDAY function is activated.
Cleaning the water tank.
1 Ensure that the tank is completely empty before removing it.
2 Clean all the elements with a clean cloth, using water only.
3 Do not use detergents or other chemical products.
4 Do not wash in the dishwasher.
5 Before putting the tank back in place, ensure that the seals
are correctly placed.
6 After water is discharged, any leaking drops are collected in
the tray located beneath the removable grille.
6
Child safety
The device is equipped with a safety system: when engaged, it
prevents children from discharging water from the appliance.
To activate the "Child Safety" system, move the lever to "Lock"
as indicated in the picture.
To deactivate the system, move the lever back into the initial
"Unlock" position.
Unlock
Lock
Freezer compartment
ICE CARE tray
The fact that they are situated on the top part of the freezer
drawers ensures greater cleanliness: the ice no longer
comes into contact with the food placed inside the freezer
compartment; furthermore, the dripping of the water during
filling is avoided (a lid to cover up the hole after filling with
water is also provided).
1. Pull out the tray by pushing it up.
Check that the tray is ompletely empty and fill it with water
through the opening provided.
2. Take care not to exceed the level indicated (MAX WATER
LEVEL). Excess water prevents the ice cubes from
dispensing (if this happens, wait for the ice to melt and
empty the tray).
3. Turn the tray 90°: due to the connected compartments each
mould fills with water (see diagram).
4. Close the opening with the lid provided and put the tray
back.
5. When the ice has formed (minimum time approximately 8
hours) knock the tray against a hard surface and wet the
outside so that the ice cubes come loose and take them out
through the opening.
MAX
WATER LEVEL