Indesit FGIM K IX Gebruiksaanwijzing - Pagina 15

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Indesit FGIM K IX. Indesit FGIM K IX 48 pagina's.

Pagina afdrukken

The figures indicated on the data plate have been

calculated for this type of installation.

Ventilation

To ensure adequate ventilation, the back panel of

the cabinet must be removed. It is advisable to

install the oven so that it rests on two strips of wood,

or on a completely flat surface with an opening of at

least 45 x 560 mm ( see diagrams ).

Centring and fastening

Secure the appliance to the cabinet by opening the

oven door and fastening 4 screws into the 4 holes of

the outer frame.

! All parts ensuring the safe operation of the

appliance must not be removable without the aid of

a tool.

Electrical connections

! Ovens equipped with a three-pole power supply

cable are designed to operate with alternating

current at the voltage and frequency indicated on

the data plate located on the appliance ( see below ).

Fitting the power supply cable

1. Open the terminal board by

inserting a screwdriver into the

side tabs of the cover. Use

the screwdriver as a lever by

pushing it down to open the

cover ( see diagram ).

2. Install the power supply

cable by loosening the cable

clamp screw and the three

wire contact screws L-N-

Connect the wires to the

corresponding terminals: the

Blue wire to the terminal

marked (N), the Brown wire to

the terminal marked (L) and

the Yellow/Green wire to the

terminal marked

diagram ).

3. Secure the cable by fastening the clamp screw.

4. Close the cover of the terminal board.

Connecting the supply cable to the mains

Install a standardised plug corresponding to the

load indicated on the data plate ( see adjacent box ).

The appliance must be directly connected to the

mains using an omnipolar circuit-breaker with a

minimum contact opening of 3 mm installed between

the appliance and the mains. The circuit-breaker

must be suitable for the charge indicated and must

comply with current electrical regulations (the earthing

wire must not be interrupted by the circuit-breaker).

The supply cable must not come into contact with

surfaces with temperatures higher than 50°C.

! The installer must ensure that the correct electrical

connection has been made and that it is compliant

with safety regulations.

Before connecting to the power supply, make sure that:

• the appliance is earthed and the plug is compliant

with the law.

• the socket can withstand the maximum power of

the appliance, which is indicated on the data

plate ( see below ).

• the voltage is in the range between the values

indicated on the data plate ( see below ).

• the socket is compatible with the plug of the

appliance. If the socket is incompatible with the

plug, ask an authorised technician to replace it.

Do not use extension cords or multiple sockets.

( see