A-Neuvideo ANI-8PDU-24V Gebruiksaanwijzing - Pagina 5

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} A-Neuvideo ANI-8PDU-24V. A-Neuvideo ANI-8PDU-24V 12 pagina's. 8-port 24v dc power manager

Pagina afdrukken

NEUVIDEO

FRONT PANEL

RS-232:

Connect directly to your PC/laptop using a 3.5mm mini-jack to 9-pin adapter to send RS-232 commands to control the unit.

ISP/RESET:

This button has multiple functions, see below.

A. ISP MODE:

Press and hold this button while powering the unit on to enter ISP mode.

B. FACTORY RESET:

of the unit.

C. REBOOT:

Momentarily press this button, after the unit is already powered on, to reboot the unit.

Rear Panel

24V POWER OUT & LEDS 1~8:

devices can be powered. When power is available from a port, the associated LED will be green. When a power port is disabled its LED

will turn off.

24V FAN OUT A~B:

Connect to a dedicated dual-fan power and control cable. Fan speed can be controlled via WebGUI, Telnet, or

RS-232.

SERV.:

This slot is reserved for firmware update use only.

CONTROL:

Connect directly, or through a network switch, to your PC/laptop to control the unit via Telnet/WebGUI.

DC 24V:

Plug the 24V DC power adapter into the unit and connect it to an AC wall outlet for power.

ON/OFF:

Flip this switch to turn the unit ON or OFF after connecting a 24V power source.

Press and hold this button for 5+ seconds, after the unit is already powered on, to perform a full factory reset

Connect power cables with 3.5mm 2-pin terminal blocks from units requiring 24V power. Up to (8)

OPERATION CONTROLS & FUNCTIONS