A-Neuvideo ANI-8PDU-24V Instrukcja obsługi - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przełącznik A-Neuvideo ANI-8PDU-24V. A-Neuvideo ANI-8PDU-24V 12 stron. 8-port 24v dc power manager
A
NEUVIDEO
FRONT PANEL
RS-232:
Connect directly to your PC/laptop using a 3.5mm mini-jack to 9-pin adapter to send RS-232 commands to control the unit.
q
ISP/RESET:
This button has multiple functions, see below.
w
A. ISP MODE:
Press and hold this button while powering the unit on to enter ISP mode.
B. FACTORY RESET:
of the unit.
C. REBOOT:
Momentarily press this button, after the unit is already powered on, to reboot the unit.
Rear Panel
24V POWER OUT & LEDS 1~8:
q
devices can be powered. When power is available from a port, the associated LED will be green. When a power port is disabled its LED
will turn off.
24V FAN OUT A~B:
Connect to a dedicated dual-fan power and control cable. Fan speed can be controlled via WebGUI, Telnet, or
w
RS-232.
SERV.:
This slot is reserved for firmware update use only.
e
CONTROL:
Connect directly, or through a network switch, to your PC/laptop to control the unit via Telnet/WebGUI.
r
DC 24V:
Plug the 24V DC power adapter into the unit and connect it to an AC wall outlet for power.
t
ON/OFF:
Flip this switch to turn the unit ON or OFF after connecting a 24V power source.
y
Press and hold this button for 5+ seconds, after the unit is already powered on, to perform a full factory reset
Connect power cables with 3.5mm 2-pin terminal blocks from units requiring 24V power. Up to (8)
OPERATION CONTROLS & FUNCTIONS
3