AEG SCE8186VTC Gebruikershandleiding - Pagina 14
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} AEG SCE8186VTC. AEG SCE8186VTC 20 pagina's.
Pagina afdrukken14
www.aeg.com
Problem
A
or
instead of numbers on the
Temperature Display.
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the "FROSTMAT-
IC" or "COOLMATIC", or af-
ter changing the tempera-
ture.
Water flows inside the refrig-
erator.
Water flows on the floor.
Possible cause
Temperature sensor prob-
symbol is shown
lem.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor-
rectly.
The "FROSTMATIC" or
"COOLMATIC" is switch-
ed on.
This is normal, no error has
occurred.
Food products prevent the
water to flow into the wa-
ter collector.
The water outlet is clog-
ged.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
Solution
Contact the nearest Author-
ised Service Centre (the cool-
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible).
Close and open the door.
Contact the nearest Author-
ised Service Centre.
Refer to "Operation".
Wait some hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Refer to "FROSTMATIC func-
tion" or "COOLMATIC func-
tion".
The compressor starts after a
period of time.
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
Attach the melting water out-
let to the evaporative tray.