AEG 2600 D Bedienings- en installatiehandleiding - Pagina 13
Blader online of download pdf Bedienings- en installatiehandleiding voor {categorie_naam} AEG 2600 D. AEG 2600 D 16 pagina's.
Ook voor AEG 2600 D: Bedienings- en installatie-instructies (20 pagina's)
Pagina afdrukken
Mounting the cooker hood - Fig. 8
Position the template (1) on the wall and mark the position, and drill the
holes (2 x Ø 8 mm).Mount the two rawl plugs with the hooks (3)
Hang the hood on the hooks and level it with the adjustment screws (4)
Remove the grease filters (5) and mark for the two screws (6). Remove
the hood and drill the holes (2 x Ø 8 mm).
Insert the rawl plugs (7) and hang the hood on the wall again. Adjust it
horizontally with the screws (8) and secure it with the screws (9)
Mount the chimney holder (10) with the rawl plugs (9a) and the screws
(11).
Be careful that it is centered over the hood and horizontally aligned.
Fitting for ducting (S)
Connect a tube between the hood air outlet and the wall or roof exhaust
channel. Fix it with the tube clamps supplied.
Fitting for recirculation
Mount the recirculation spigot (12) with the two screws (13) supplied.
Mounting the chimney
Place the chimney and fix it to the top chimney holder with the two
screws (16) supplied.
Lower the bottom part of the chimney and fasten it to the top of the
hood with two screws (17), supplied.
Note that the top part of the chimney can be mounted with the side grids up
or down. For use as a recirculation hood it must be mounted with the grids
upwards. (Fig. 7).
Fig. 7
13