- ページ 13

換気フード AEG 2600 DのPDF 操作および設置マニュアルをオンラインで閲覧またはダウンロードできます。AEG 2600 D 16 ページ。
AEG 2600 D にも: 操作およびインストール手順 (20 ページ)

AEG 2600 D 操作および設置マニュアル
Mounting the cooker hood - Fig. 8
Position the template (1) on the wall and mark the position, and drill the
holes (2 x Ø 8 mm).Mount the two rawl plugs with the hooks (3)
Hang the hood on the hooks and level it with the adjustment screws (4)
Remove the grease filters (5) and mark for the two screws (6). Remove
the hood and drill the holes (2 x Ø 8 mm).
Insert the rawl plugs (7) and hang the hood on the wall again. Adjust it
horizontally with the screws (8) and secure it with the screws (9)
Mount the chimney holder (10) with the rawl plugs (9a) and the screws
(11).
Be careful that it is centered over the hood and horizontally aligned.
Fitting for ducting (S)
Connect a tube between the hood air outlet and the wall or roof exhaust
channel. Fix it with the tube clamps supplied.
Fitting for recirculation
Mount the recirculation spigot (12) with the two screws (13) supplied.

Mounting the chimney

Place the chimney and fix it to the top chimney holder with the two
screws (16) supplied.
Lower the bottom part of the chimney and fasten it to the top of the
hood with two screws (17), supplied.
Note that the top part of the chimney can be mounted with the side grids up
or down. For use as a recirculation hood it must be mounted with the grids
upwards. (Fig. 7).
Fig. 7
13