AEG 502 D Bedienings- en installatie-instructies - Pagina 15
Blader online of download pdf Bedienings- en installatie-instructies voor {categorie_naam} AEG 502 D. AEG 502 D 20 pagina's. Electrolux extractor hood installation and operating instructions
Ook voor AEG 502 D: Handleiding voor installatie en gebruik (16 pagina's)
Pagina afdrukken
Always turn off the electricity before replacing lamps!
1) Remove the grid (Fig. 2) in order to check the lamps and
replace them if necessary.
A
2
2) Unscrew the lamps that do not work and replace them with
40W max lamps (E14).
If the light does not function, check that the lamps are properly
screwed before contacting a customers' service centre.
Warning: always disconnect the hood from the mains power
supply before cleaning it.
Never insert pointed objects in the motor's protective grille.
Wash the outside surfaces using a mild detergent solution.
Never use caustic detergents or abrasive brushes or pow-
ders.
Only ever clean the switch panel and filter grille using a damp
cloth and mild detergents.
It is extremely important to clean the unit and change the
filters at the recommended intervals. Failure to do so will
cause grease deposits to build up that could constitute a fire
hazard.
Attention
Failure to observe the rules for cleaning the appliance and
changing and cleaning the filters may cause fire. Therefore,
properly observing these instructions is highly recommended.
Replacing
the lamps
A
Cleaning
15