Aqua Creek Products F-019CA-01 Instructies voor bevestiging - Pagina 3

Blader online of download pdf Instructies voor bevestiging voor {categorie_naam} Aqua Creek Products F-019CA-01. Aqua Creek Products F-019CA-01 7 pagina's.

Pagina afdrukken

Aqua Creek Products F-019CA-01 Instructies voor bevestiging

The Cycle Attachment will work on any

standard Aqua Creek Products chair

assembly. Shown above is the Cycle

Attachment being installed on the Pro Pool

lift.

STEP 1: Remove the 2" square plastic end

cap from the front of the chair support tube

(front of chair between legs, see FIGURE 3).

STEP 2: Slide the Bike Pedal Attachment

into the chair support tube. Align one

of the leg length adjustment holes with

the holes through the chair and the chair

support tube (FIGURE 3).

STEP 3: Install 5/16" spring pin into aligned

holes, and clip the spring over the end.

The Cycle Attachment is now ready for use.

Assembly Instructions

LEG LENGTH

ADJUSTMENT

CYCLE ATTACHMENT

FIGURE 2

SPRING PIN

[2] REPLACE 2X2 CAP WITH

CYCLE ATTACHMENT

& BPA-440-10

[1] REMOVE 2X2 PLASTIC CAP

[3] INSERT 5/16" SPRING PIN

(ADJUST LEG LENGTH AND

INSERT IN NEAREST HOLE)

FIGURE 3

Revised 2/21/18