Aqua Creek Products F-019CA-01 Instruções de anexação - Página 3
Procurar online ou descarregar pdf Instruções de anexação para Equipamento de fitness Aqua Creek Products F-019CA-01. Aqua Creek Products F-019CA-01 7 páginas.
The Cycle Attachment will work on any
standard Aqua Creek Products chair
assembly. Shown above is the Cycle
Attachment being installed on the Pro Pool
lift.
STEP 1: Remove the 2" square plastic end
cap from the front of the chair support tube
(front of chair between legs, see FIGURE 3).
STEP 2: Slide the Bike Pedal Attachment
into the chair support tube. Align one
of the leg length adjustment holes with
the holes through the chair and the chair
support tube (FIGURE 3).
STEP 3: Install 5/16" spring pin into aligned
holes, and clip the spring over the end.
The Cycle Attachment is now ready for use.
Copyright © 2018 Aqua Creek Products All Rights Reserved
Assembly Instructions
LEG LENGTH
ADJUSTMENT
CYCLE ATTACHMENT
FIGURE 2
SPRING PIN
[2] REPLACE 2X2 CAP WITH
CYCLE ATTACHMENT
& BPA-440-10
[1] REMOVE 2X2 PLASTIC CAP
[3] INSERT 5/16" SPRING PIN
(ADJUST LEG LENGTH AND
INSERT IN NEAREST HOLE)
FIGURE 3
Revised 2/21/18
3