Aqua Laser Delta Sweeper 815.566 Gebruiksaanwijzing - Pagina 5

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Aqua Laser Delta Sweeper 815.566. Aqua Laser Delta Sweeper 815.566 11 pagina's.

Pagina afdrukken

To assemble the Aqua Laser Delta Sweeper

Remove the Aqua Laser Delta Sweeper and its components from the box.

IMPORTANT: properly dispose of the plastic bubble wrapping. Keep away from babies

and children.

Step 1. Screw the three pole sections until secure.

Step 2. Align the arrow on the bottom end of the pole with the arrow on the top end of

the pole base. Now with your thumb and pointer finger, simultaneously depress the

two buttons on either side of the plastic connector at the top of the pole base and, with

your other hand, slide the pole all the way down until it locks into place.

Charging the battery

Step 1. Plug the battery charger into a standard electrical outlet as below:

UL/cUL – 120V AC 60Hz

TUV/UK – 220-240V AC 50/60Hz

Step 2. Align the arrow on the rechargeable battery with the arrow on the battery charger. Then

insert the rechargeable battery down into the battery charger. NOTE: red light on the front of the

battery charger should turn on to indicate that the battery is charging.

IMPORTANT: for initial battery charge, let battery charge for at least 8 full hours. When

recharging, charge time will vary dependent upon the amount of power that is left in the battery

after its last use. Recommended recharging time for the battery after completely depleting it is 6-

8 hours. Battery may be left in charger for extended periods of time but do not exceed 24

consecutive hours. Doing so may lead to shortened overall battery life. It is not necessary to wait

until battery power is fully depleted before recharging.

Using the Aqua Laser Delta Sweeper

Step 1. Make sure the Aqua Laser Delta Sweeper is turned off. The on/off

switch is located on the front of the battery compartment.

Step 2. Make sure the dirt tray is empty (see following directions on emptying

the dirt tray).

Step 3. Insert the rechargeable battery down into the battery compartment

located on the front of the pole until it locks into place.

Step 4. Turn the Aqua Laser Delta Sweeper on to begin cleaning.

Step 5. When you are done cleaning, turn the Aqua Laser Delta Sweeper off. Remove the dirt tray and empty the

dirt & debris into a garbage receptacle. Recharge the battery if necessary.

Components

1. Handle

2. Heavy duty aluminum pole

3. Rechargeable 7.2V battery

4. Battery compartment

5. On/Off switch

6. Pole base

7. Tinted outer body frame

8. Base

9. Outer body frame lock clips

10. Dirt tray lock clips

11. Dirt tray

12. Rotating cleaning brushes

13. Battery charger

14. Brush cleaning tool & storage cover