Aqua Laser Delta Sweeper 815.566 Gebruiksaanwijzing - Pagina 6

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Aqua Laser Delta Sweeper 815.566. Aqua Laser Delta Sweeper 815.566 11 pagina's.

Emptying the dirt tray
Step 1. Make sure the Aqua Laser Delta Sweeper is turned off.
Step 2. With the Sweeper base sitting on the floor or other flat surface such as a countertop,
squeeze and hold the dirt tray lock clips with one hand and lift the sweeper up by its aluminum
pole with the other hand, to release the dirt tray.
Step 3. Empty the dirt and debris into a garbage receptacle.
Step 4. Then, place the dirt tray back on the floor or other flat surface. Lift up and align the base
of the sweeper over the dirt tray. IMPORTANT: if dirt tray does not securely connect back into
place, check to make sure that no small metal debris (e.g. staples, paperclips etc.) has
magnetized to the sweeper's motor located on the underside of the base.
Maintaining your Aqua Laser Delta Sweeper
Over time, as with any rotating bristle cleaning device, the Aqua Laser Delta Sweeper four cleaning
brushes will accumulate fine debris such as hair, tread and other particles. We recommend cleaning the
rotating brushes on occasion using the included brush cleaning tool.
Step 1. Make sure the Aqua Laser Delta Sweeper is turned off and remove the battery to ensure the unit
does not accidentally turn on.
Step 2. Unlock the tinted outer body frame by sliding the two outer body frame lock clips inward towards
the pole.
Step 3. Next, lift the tinted outer body frame up and over the aluminum pole to remove it. The four
brushes are now completely exposed.
Caution: brush cleaning tool has sharp tip and ripping blade. Avoid contact with tip and ripping blade.
Step 4. Use the brush cleaning tool to cut and remove tangled debris. Simply guide the blade
along the shaft of the rotating cleaning brushes. Dispose of debris in garbage.
Step 5. Replace the tinted outer body frame and lock by sliding the outer body frame lock
clips outward and away from the pole.
Periodically wipe down your Aqua Laser Delta Sweeper with a dry or damp lint-free cloth. Do
not use water, liquid cleaners or abrasive materials to clean the Aqua Laser Delta Sweeper.
Basic Troubleshooting
the Aqua Laser Delta Sweeper is sluggish or won't start:
5.
Make sure the battery is fully charged and securely inserted into the battery compartment, and that the
pole section with the battery compartment is securely connected to the pole base.
6.
Battery not charging:
Make sure the battery is fully inserted into the battery charger. Also, check to make sure that the red
indicator light on the battery charger comes on when charging.
7.
the Aqua Laser Delta Sweeper is operating but not picking up mess:
The dirt tray may be full. Empty out if necessary. Also, some debris may be lodged in carpeting (such as
staples) or may be too large/heavy for the sweeper to pick up. Make sure the dirt tray is attached.
8.
Dirt & debris is escaping from sweeper during cleaning :
Make sure the dirt tray is empty and securely connected to the sweeper. Also, check to see that the
rotating cleaning brushes are not entangled with debris such as hair, paper etc. Use the brush cleaning
tool to clean off, if necessary.
Technical data:
AC Adapter input
AC Adapter output
Adapter
Voltage battery
Rated power of appliance
Charging current for empty battery
Operating time with full charge
Correct Disposal of this product
This marking indicates that this product should not be disposed with other household wastes
throughout the EU. To prevent possible harm to the environment or human health from uncontrolled
waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems or contact the retailer where the
product was purchased. They can take this product for environmental safe recycling.
230V ~ 50 Hz 35mA
7,5V --- 250mA
1200mAh Ni-MH
7.2 V
6 W.
6-8 H.
60 MIN.