Avocent LongView IP Snelle installatiehandleiding
Blader online of download pdf Snelle installatiehandleiding voor {categorie_naam} Avocent LongView IP. Avocent LongView IP 2 pagina's. Desktop extension over ip solutions
Ook voor Avocent LongView IP: Specificaties (4 pagina's)
Pagina afdrukken
The following instructions will help you
install your LongView IP KVM extender.
For more information, consult the LongView
IP KVM Extender Installer/User Guide.
Supporting both PS/2 and USB connections,
the LongView IP KVM extender features a local
receiver and a USB transmitter capable of extending
keyboard, video and mouse (KVM) signals within the
parameters of the Local Area Network (LAN).
1
Connecting power to the receiver
Locate the power supply and AC line cord. Plug the
DC connector of the power supply into the matching
socket on the rear of the receiver. Attach the AC line
cord to the power supply, then plug the line cord into
an appropriate power source.
2
Preparing the remote workstation
Set the screen resolution and refresh rates of the
workstation according to the table on the opposite
side of this Quick Installation Guide. Next, turn off the
workstation and attach the transmitter.
3
Connecting the transmitter
Attach the transmitter to the video, audio, microphone
and two USB ports on the workstation. An optional
power supply unit may be used to power the
transmitter in lieu of two USB connections. Turn on
the workstation.
4
Establishing LAN connections
The connection between transmitter and receiver units
may be established using a straight-through or cross-
over UTP cable, or industry-standard Ethernet hubs or
switches. Connections across subnets are supported.
To Contact Avocent Technical Support
Avocent, the Avocent logo, The Power of Being There and LongView are registered trademarks of Avocent Corporation or its affiliates. All other marks are the property of their respective owners. ©2007 Avocent Corporation. All rights reserved.
Quick Installation Guide
LongView
KVM Extender
To install the LongView IP KVM extender
1
PS/2
Ports
2
Remote
Workstation
Consult the installer/user guide for details on setting the IP
address of the transmitter and
receiver.
5
Connecting the peripherals
Attach the monitor, keyboard, mouse and audio cables to
the receiver. A removable drive can be hot-plugged into the
USB ports on the receiver at any time.
6
Setting the transmitter
The transmitter is pre-configured for digital video. Analog
video extension must be selected via the transmitter's serial
CALL (888) 793-8763
The Power of Being There
IP
®
Video
Ethernet
Port
4
6
Transmitter
Optional power supply is
required only if two USB
3
connections are not available.
menu interface. Within the Console Settings sub-
menu, select VGA to choose analog video.
For additional information
For further information regarding hardware
connection, setup and troubleshooting, please refer
to the installer/user guide. Visit www.avocent.com for
LongView IP KVM extender product updates.
VISIT www.avocent.com/support
®
Microphone
Speakers
USB Ports
Serial Port
5
DOWNLOAD www.avocent.com
590-720-501A