Billi Sahara Installatiehandleiding - Pagina 5
Blader online of download pdf Installatiehandleiding voor {categorie_naam} Billi Sahara. Billi Sahara 8 pagina's.
Ook voor Billi Sahara: Installatiehandleiding (7 pagina's), Gebruikershandleiding (12 pagina's)
Pagina afdrukken
Installing
underbench module.
1. Flush Water Supply
Flush water supply pipework before installing
the underbench unit by connecting 600mm
flexible braided hose to the supply tap and
running water into a bucket. Blockages/unit
malfunction caused by debris are not covered
under warranty.
2. Install Underbench Unit
Take care to observe minimum clearances.
Ensure there is adequate access to service
the unit, taking into account the tube lengths
and space available Refer Diagram 1, page 2.
3. Connect Dispenser Tubing
and Electrical Plug
IMPORTANT: Boiling outlet (red), vent tube
(grey) must not be kinked and must be installed
with a continual fall and no sag.
Connect all tubing and electrical plug as
shown in diagram 17a & 18a for the Sahara
310 and Diagram 17b & 18b for the Sahara &
Sahara Plus 320, 360, 3120 models.
Ensure correct orientation of dispenser
power plug before insertion. Trim tubes to
correct lengths using a sharp knife or plastic
tube cutter. Avoid leaving excess tubing which
will sag, trapping water. Fit spring clamps
supplied to retain silicone rubber tubing to
barbed fittings.
Sahara 310
power cord
flexible hose
Top View
dispenser
boiling
ambient
power
(red)
(blue)
cord
hot vent
(grey)
Sahara 320, 360, 3120 & Sahara Plus Models
power cord
1/2" stop tap
(installed by plumber)
Diagram 17a
Top View
water
supply
Diagram 18a
flexible hose
1/2" stop tap
(installed by plumber)
Diagram 17b
power
dispensor
ambient
supply
power
(blue)
water
cord
supply
boiling
vent
(red)
(grey)
Diagram 18b
5