Aqua Optima AWD001 Gebruiksaanwijzing - Pagina 5
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Aqua Optima AWD001. Aqua Optima AWD001 8 pagina's.
Ook voor Aqua Optima AWD001: Gebruiksaanwijzing (8 pagina's)
Pagina afdrukken
Power up
•
Put the plug into the wall socket (switch the socket on if it's switchable).
•
The light will come on, and the fan will start up - you may hear it in the background.
•
Initially, the light will be deep blue. It'll change to be pale blue or white when the water in the
cooling unit has reached drinking temperature. This takes about an hour and a half, depending on
local conditions( temperature, humidity/pressure).
Cartridge life indcator
•
After you fi t a new fi lter, you must set the cartridge
life indicator so it can remind you when the fi lter
needs replacing.
•
The fi rst time you see the timer, the display will
be blank, to conserve the battery.
•
Every other time you need to set it, it'll be fl ashing
continuously, to tell you the fi lter needs replacing.
•
The display has 6 parts: bulleye, inner ring, and 4
outer segments.
AQUA OPTIMA 30 day single life fi lter
a) Press and hold the RESET button for 4-8 seconds, then let go.
b) The top left segment will turn black, but only the bullseye will fl ash.
c) The outer segments will measure 7 days each, not 15 days.
d) When the fi lter comes to the end of it's life, everything except the inner ring will fl ash.
e) Should you have any problems, refer to " troubleshooting", page 6.
Using the tap
•
Wait till the light has changed from deep blue to pale blue or white before taking water from the
cooler.
•
Hold a suitable container against the tap to allow the water to fl ow.
•
As you take water from the cooling unit, it's replaced by water from the water tank, so the light
may turn deep blue again.
•
The cooling unit holds about 1.2 litres of water, and the layer of water at the bottom of the wa-
ter tank, just above the cooling unit, will be almost as cold, so you can probably take about a litre
and a half before you lose the cool taste.
•
If you empty the cooling tank, wait until the light turns pale blue/white before taking any more.
Topping up
•
You may top the water up at any time, you don't need to keep the fi lter submerged.
•
Try to keep the water level at least half way up to the water tank, as the head of the water in the
water tank provides the force that dispenses the water through the spout.
•
If the water level falls below the bottom of the water tank, the spout will dry up.
Emptying
There's a drain plug underneath the cooling unit which must be unscrewed to empty the cooling unit
of the last 1.2litres of water (Fig.5).
a) Use up all the water in the water tank, and let it run dry.
b) Unplug the cooler.
c) Remove the lid, and lift out the fi lter holder (leave the fi lter attached to it).
AWD001 - Water dispenser_IM.indd 5
AWD001 - Water dispenser_IM.indd 5
top left
segment
outer
segment
press
4.
outer
segment
inner ring
RESET
bullseye
2/13/2008 3:27:06 PM
2/13/2008 3:27:06 PM