Aqua Optima AWD001 Gebruiksaanwijzing - Pagina 6
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Aqua Optima AWD001. Aqua Optima AWD001 8 pagina's.
Ook voor Aqua Optima AWD001: Gebruiksaanwijzing (8 pagina's)
Pagina afdrukken
d) Carry the cooler into the kitchen (carry it empty – when the cooler is full, the water
alone weighs 7kg).
e) Support the cooler with one arm, rest the bottom edge of the cooler on the edge of the
kitchen sink, so that the drain plug is over the sink.
f) Use a coin to unscrew the drain plug.
g) When it's empty, screw the drain plug back in, and wipe off any spillage.
When to change the fi lter
•
To maintain water quality, you must change the fi lter regularly. If you don't you'll
end up returning all the nasties from the fi lter into your drinking water.
•
When the fi lter needs replacing, the display will fl ash.
Low usage
If you don't use enough water to top the cooler up at least once a day, we suggest that you empty the
cooler completely at least once a week, and clean it out- see 'care and maintenance' below.
Care and maintenance
•
Don't put any part of the appliance in a dishwasher – the harsh environment inside the
dishwasher will affect the surface fi nishes.
•
Do not use harsh or abrasive cleaning agents or solvents.
1. Unplug the cooler
2. If it's not already empty, empty the water tank via the tap and spout.
3. Remove the fi lter from the fi lter holder, then carefully remove the seal from the fi lter
holder.
5. Wipe the fi lter, seal, fi lter holder, lid, and the inside of the water tank with a clean damp cloth.
6. Don't use washing up liquid or anything else that might leave a taint.
7 . Wipe the outside surfaces of the cooler with a clean damp cloth. If necessary, you may use a little
household detergent afterwards, to avoid tainting the water.
8. Replace the seal, then replace the fi lter in the fi lter holder.
9. Replace the fi lter holder in the water tank.
10. Fill the water tank and the fi lter holder to within 1cm of the top of the fi lter holder and replace
the lid.
11. Empty the water tank via the tap and spout, to fl ush out the cooling unit.
12. Fill the water tank and fi lter holder to within 1cm of the top of the fi lter holder and replace the
lid.
13. Plug the cooler into the wall socket, and leave it for 90minutes, when the light turns pale blue
to white, the water should be chilled.
Troubleshooting
•
If you follow the instructions correctly, you shouldn't see anything else in the
display.
•
If you accidently press the RESET button while you're cleaning the cooler,
you may be treated to a performance of the display check routine – each
segment will fl ash in turn, then the display will return to normal.
•
As long as you don't keep the RESET button pressed for more than 3 seconds,
you wont do any harm.
•
If you press it for longer than this, you'll lose your current settings and the display
will fl ash constantly.
AWD001 - Water dispenser_IM.indd 6
AWD001 - Water dispenser_IM.indd 6
5.
2/13/2008 3:27:06 PM
2/13/2008 3:27:06 PM