Abacus Electric Evolve Sonix Gebruikershandleiding - Pagina 6

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Abacus Electric Evolve Sonix. Abacus Electric Evolve Sonix 10 pagina's. Wireless gsm alarm

Pagina afdrukken

- 123456#81#The front window opened# will save the fourth SMS message that is sent after

connecting the fourth wireless detector

- 123456#81#The back window opened# will save the fifth SMS message that is sent after connecting

the fifth wireless detector

- 123456#81#The middle window opened# will save the sixth SMS message that is sent after

connecting the sixth wireless detector

- 123456#81#The attic entrance opened# will save the seventh SMS message that is sent after

connecting the first wire detector on the ports 1 - 3

How to test the alarm main drive?

When you turn on the alarm main drive and it is unactivated, the green LED warning light will shine

continuously on it. You can change it to activated state using the remote control or by sendind the SMS

message (123456#1#1#) where the LED warning light will start blinking green.

a. In the activated mode with the blinking green LED warning light connect the input ports (I1, I2,

I3) or disconnect the connected wire or activate any wireless detector or press the distress

button on the remote control. The alarm should automaticly send the SMS message and dial one

of the saved numbers.

b. The SMS message is sent before dialling the telephone number. If the SMS function was

deactivated or limited, only the phone numbers will be dialled. You can finish this process using

the remote control.

c. When the alarm triggers and dialling the telephone numbers starts, you can answer the call

straight without the necessity entering the password and turn off the alarm from the distance or

reset the device. By pressing the 3#1# you switch on the siren and by pressing 3#0# you turn it

off; by pressing 4#1# you can eavesdrop what´s happening in the room and by pressing 4#0# you

end the eavesdropping; by pressing 93#1# you can talk to the intruder by the alarm, where you

can turn this function off by pressing 93#0#.

d. When the alarm triggers and dialling the telephone numbers starts, you can answer the call

straight without the necessity entering the password and end dialling other numbers from the

distance. It only takes to press the buttons 1#1# or 1#2# on the phone, and therethrough you

switch over the alarm back to the activated mode.

e. When the alarm triggers, you can also, in case that you are around, turn off the alarm by the

remote control.

f. The device has the inner battery and it will send the message 'external power failure' or

'external power recovery' in case of the power failure and after that the resumption of the

power supply (from the grid).

How to control the alarm main drive?

a. By sending the SMS to the SIM card number that is inside of the device. Send to the alarm the SMS in

this form: 123456# and put one of the control command behind the symbol #;

b. Dial the SIM card number that is inside of the device. Call the alarm number and enter the password

123456# and put one of the control commands behind the symbol #:

The list of the control commands:

Code

Function

1#1#

Full activation* (all the sensors work)

Code

Function

1#2#

Partial activation (part of the sensors work)