Abacus Electric Evolve Sonix Podręcznik użytkownika - Strona 6
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla System bezpieczeństwa Abacus Electric Evolve Sonix. Abacus Electric Evolve Sonix 10 stron. Wireless gsm alarm
Drukuj stronę- 123456#81#The front window opened# will save the fourth SMS message that is sent after
connecting the fourth wireless detector
- 123456#81#The back window opened# will save the fifth SMS message that is sent after connecting
the fifth wireless detector
- 123456#81#The middle window opened# will save the sixth SMS message that is sent after
connecting the sixth wireless detector
- 123456#81#The attic entrance opened# will save the seventh SMS message that is sent after
connecting the first wire detector on the ports 1 - 3
How to test the alarm main drive?
When you turn on the alarm main drive and it is unactivated, the green LED warning light will shine
continuously on it. You can change it to activated state using the remote control or by sendind the SMS
message (123456#1#1#) where the LED warning light will start blinking green.
a. In the activated mode with the blinking green LED warning light connect the input ports (I1, I2,
I3) or disconnect the connected wire or activate any wireless detector or press the distress
button on the remote control. The alarm should automaticly send the SMS message and dial one
of the saved numbers.
b. The SMS message is sent before dialling the telephone number. If the SMS function was
deactivated or limited, only the phone numbers will be dialled. You can finish this process using
the remote control.
c. When the alarm triggers and dialling the telephone numbers starts, you can answer the call
straight without the necessity entering the password and turn off the alarm from the distance or
reset the device. By pressing the 3#1# you switch on the siren and by pressing 3#0# you turn it
off; by pressing 4#1# you can eavesdrop what´s happening in the room and by pressing 4#0# you
end the eavesdropping; by pressing 93#1# you can talk to the intruder by the alarm, where you
can turn this function off by pressing 93#0#.
d. When the alarm triggers and dialling the telephone numbers starts, you can answer the call
straight without the necessity entering the password and end dialling other numbers from the
distance. It only takes to press the buttons 1#1# or 1#2# on the phone, and therethrough you
switch over the alarm back to the activated mode.
e. When the alarm triggers, you can also, in case that you are around, turn off the alarm by the
remote control.
f. The device has the inner battery and it will send the message 'external power failure' or
'external power recovery' in case of the power failure and after that the resumption of the
power supply (from the grid).
How to control the alarm main drive?
a. By sending the SMS to the SIM card number that is inside of the device. Send to the alarm the SMS in
this form: 123456# and put one of the control command behind the symbol #;
b. Dial the SIM card number that is inside of the device. Call the alarm number and enter the password
123456# and put one of the control commands behind the symbol #:
The list of the control commands:
Code
Function
1#1#
Full activation* (all the sensors work)
Code
Function
1#2#
Partial activation (part of the sensors work)
47