Dell Inspiron 1501 - Turion X2 TL-60 2GB DDR2 Servicehandleiding - Pagina 17
Blader online of download pdf Servicehandleiding voor {categorie_naam} Dell Inspiron 1501 - Turion X2 TL-60 2GB DDR2. Dell Inspiron 1501 - Turion X2 TL-60 2GB DDR2 41 pagina's. Dell inspiron 1501 setting up
Ook voor Dell Inspiron 1501 - Turion X2 TL-60 2GB DDR2: Installatiehandleiding (2 pagina's), Installatiehandleiding (2 pagina's), Uw computer instellen (2 pagina's)
Pagina afdrukken
1 M2.5 x 5-mm screws
2 display cable
(2)
4 captive screw
5 antenna cables (2)
7 standby switch
8 display cable connector on system
board
12. Lift the display up and away from the computer.
NOTICE:
The standby switch is fragile and easily broken. Avoid knocking the switch when removing and replacing the display.
Replacing the Display Assembly
NOTE:
Ensure the display and antenna cables are not twisted and are clear of the computer base before replacing the display.
1. Place the display onto the computer base.
2. Replace the two M2.5 x 5-mm screws in the display hinge.
3. Securely route the display cable under the tabs in the cable channel.
4. Connect the display cable to the system board and tighten the captive screw.
5. Securely route the antenna cables under the tabs in the antenna cable channel. If a Mini-Card is installed, connect the antenna cables to the card (see
Replacing a
Mini-Card).
6. Replace the keyboard (see
7. Replace the hinge cover (see
8. Close the display.
9. Replace the two M2.5 x 8-mm screws in the back of the computer and replace the two screw covers.
10. Turn the computer over and replace the two M2.5 x 8-mm screws in the bottom of the computer.
Display Bezel
CAUTION:
Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
Replacing the
Keyboard).
Replacing the Hinge
Cover).
3 display cable pull-tab
6 antenna cable
channel
9 display cable channel