Dell PowerEdge 1655MC Hardware Handleiding - Pagina 3

Blader online of download pdf Hardware Handleiding voor {categorie_naam} Dell PowerEdge 1655MC. Dell PowerEdge 1655MC 10 pagina's. Removing a fan
Ook voor Dell PowerEdge 1655MC: Aanvullende handleiding (24 pagina's), Hardware Handleiding (14 pagina's)

Pagina afdrukken

Dell PowerEdge 1655MC Hardware Handleiding

This document provides instructions for replacing the server module board on server

modules. After you replace the server module board, you must run the PERC 4/im DOS

utility the first time you turn on your

function properly.

NOTE: It is recommended that you run the utility on all server modules after

replacing the server module board regardless of the server modules current

configuration. The utility must be run on all server modules that have mirrored SCSI

hard drives. The utility should be run on all server modules that have two hard drives

because you cannot tell their state until after you run the utility. The utility should be

run on server modules that have one hard drive because you would not be able to add

another hard drive and configure a mirror at a later time unless you found and ran the

utility then.

To replace a server module board, perform the following steps:

Remove the server module from the system. See "Removing a Server Module" in the

system Service Manual.

Replace the server module board. See "Server Module Board" in the system Service

Manual.

NOTICE: Do not turn on the server module when performing step 3, or your server module

will not function properly. For proper performance, do not turn on the server module until

step 6.

Install the server module in the system, but do not power on the server module. See

"Installing a Server Module" in the system Service Manual.

NOTICE: You must run the PERC 4/im DOS utility during the first server module boot after

replacing the server module board. You must run this utility only once. If you attempt to run the

PERC 4/im DOS utility after the server module has booted to the operating system or if you

attempt to run the utility more than once, the utility will not function properly.

NOTICE: If you have replaced the server module board in a server module that had mirrored

hard drives and that server module attempts to boot to the Microsoft

system before the PERC 4/im DOS utility is run, your server module will be inoperable. To make

it operational, you must reconfigure the mirror and reinstall the operating system.

With the USB diskette drive disconnected from the server module, insert the

PERC 4/im DOS Utility diskette into the USB diskette drive.

Connect the USB diskette drive to the server module.

Turn on the server module.

NOTE: A monitor must be connected to the video connector on the systems management

module.

to ensure that the SCSI hard drives

server module

Se r v e r Mo dule Bo ar d Re plac em e nt

Windows

operating

1-1