Dell PowerEdge 1655MC Donanım Kılavuzu - Sayfa 3
Sunucu Dell PowerEdge 1655MC için çevrimiçi göz atın veya pdf Donanım Kılavuzu indirin. Dell PowerEdge 1655MC 10 sayfaları. Removing a fan
Ayrıca Dell PowerEdge 1655MC için: Tamamlayıcı Kılavuz (24 sayfalar), Donanım Kılavuzu (14 sayfalar)
This document provides instructions for replacing the server module board on server
modules. After you replace the server module board, you must run the PERC 4/im DOS
utility the first time you turn on your
function properly.
NOTE: It is recommended that you run the utility on all server modules after
replacing the server module board regardless of the server modules current
configuration. The utility must be run on all server modules that have mirrored SCSI
hard drives. The utility should be run on all server modules that have two hard drives
because you cannot tell their state until after you run the utility. The utility should be
run on server modules that have one hard drive because you would not be able to add
another hard drive and configure a mirror at a later time unless you found and ran the
utility then.
To replace a server module board, perform the following steps:
Remove the server module from the system. See "Removing a Server Module" in the
1
system Service Manual.
Replace the server module board. See "Server Module Board" in the system Service
2
Manual.
NOTICE: Do not turn on the server module when performing step 3, or your server module
will not function properly. For proper performance, do not turn on the server module until
step 6.
Install the server module in the system, but do not power on the server module. See
3
"Installing a Server Module" in the system Service Manual.
NOTICE: You must run the PERC 4/im DOS utility during the first server module boot after
replacing the server module board. You must run this utility only once. If you attempt to run the
PERC 4/im DOS utility after the server module has booted to the operating system or if you
attempt to run the utility more than once, the utility will not function properly.
NOTICE: If you have replaced the server module board in a server module that had mirrored
hard drives and that server module attempts to boot to the Microsoft
system before the PERC 4/im DOS utility is run, your server module will be inoperable. To make
it operational, you must reconfigure the mirror and reinstall the operating system.
With the USB diskette drive disconnected from the server module, insert the
4
PERC 4/im DOS Utility diskette into the USB diskette drive.
Connect the USB diskette drive to the server module.
5
Turn on the server module.
6
NOTE: A monitor must be connected to the video connector on the systems management
module.
to ensure that the SCSI hard drives
server module
Se r v e r Mo dule Bo ar d Re plac em e nt
®
®
Windows
operating
1-1