Dell PowerEdge 4400 Installatiehandleiding - Pagina 18

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Dell PowerEdge 4400. Dell PowerEdge 4400 20 pagina's. Wake-on-lan (wol) support on dell servers
Ook voor Dell PowerEdge 4400: Installatiehandleiding (42 pagina's), Installatiehandleiding (28 pagina's), Installatie rek (37 pagina's), Handleiding bijwerken (8 pagina's), Informatie-update (8 pagina's), Gebruikershandleiding (42 pagina's), Installatie rek (34 pagina's), Hardware installatiehandleiding (40 pagina's), Installatiehandleiding (36 pagina's), Handmatig (15 pagina's)

(Rev. 11/3/98) FILE LOCATION: S:\SYSTEMS\SlimFast\ts\ProcUpgrade\028WD\028wdeb0.fm

1-14

Microprocessor Upgrade Installation Guide

Pivot the retention clips away from the guide-bracket assembly.

Slide the terminator card out of the guide-bracket assembly.

,QVWDOOLQJ D 7HUPLQDWRU &DUG

To install a terminator card in the guide-bracket assembly, perform the following steps:

Slide the terminator card into the guide-bracket assembly until the edge connec-

tor on the terminator card is firmly seated in the connector on the system board.

Place the retention clips on each end of the guide bracket in the notches on the

ends of the guide bracket, and then close the two latches to secure the termina-

tor card in the bracket.

5HPRYLQJ WKH 6(& &DUWULGJH DQG +HDW 6LQN $VVHPEO\

To remove the SEC cartridge and heat sink assembly, perform the following steps.

,QVWDOODWLRQ DQG 7URXEOHVKRRWLQJ *XLGH

Turn off the system, including any attached peripherals, and disconnect the AC

power cable from its power source.

*XLGH

Remove the computer cover.

Remove the cooling shroud.

Lift the latches on each end of the guide-bracket assembly.

Pivot the retention clips away from the guide-bracket assembly.

Slide the SEC cartridge and heat sink assembly out of the guide-bracket

assembly.

DELL CONFIDENTIAL - Preliminary

'HOO 3RZHU(GJH 6\VWHPV

,QVWDOODWLRQ DQG 7URXEOHVKRRWLQJ

9/11/00