Dell PowerEdge 4400 Kurulum Kılavuzu - Sayfa 18

Depolama Dell PowerEdge 4400 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Dell PowerEdge 4400 20 sayfaları. Wake-on-lan (wol) support on dell servers
Ayrıca Dell PowerEdge 4400 için: Kurulum Kılavuzu (42 sayfalar), Kurulum Kılavuzu (28 sayfalar), Raf Kurulumu (37 sayfalar), Güncelleme Kılavuzu (8 sayfalar), Bilgi Güncellemesi (8 sayfalar), Kullanıcı Kılavuzu (42 sayfalar), Raf Kurulumu (34 sayfalar), Donanım Kurulum Kılavuzu (40 sayfalar), Kurulum Kılavuzu (36 sayfalar), Manuel (15 sayfalar)

Sayfayı Yazdır
Dell PowerEdge 4400 Kurulum Kılavuzu
(Rev. 11/3/98) FILE LOCATION: S:\SYSTEMS\SlimFast\ts\ProcUpgrade\028WD\028wdeb0.fm
1-14
Microprocessor Upgrade Installation Guide
5.
Pivot the retention clips away from the guide-bracket assembly.
6.
Slide the terminator card out of the guide-bracket assembly.
,QVWDOOLQJ D 7HUPLQDWRU &DUG
To install a terminator card in the guide-bracket assembly, perform the following steps:
1.
Slide the terminator card into the guide-bracket assembly until the edge connec-
tor on the terminator card is firmly seated in the connector on the system board.
2.
Place the retention clips on each end of the guide bracket in the notches on the
ends of the guide bracket, and then close the two latches to secure the termina-
tor card in the bracket.
5HPRYLQJ WKH 6(& &DUWULGJH DQG +HDW 6LQN $VVHPEO\
To remove the SEC cartridge and heat sink assembly, perform the following steps.
,QVWDOODWLRQ DQG 7URXEOHVKRRWLQJ *XLGH
1.
Turn off the system, including any attached peripherals, and disconnect the AC
power cable from its power source.
*XLGH
2.
Remove the computer cover.
3.
Remove the cooling shroud.
4.
Lift the latches on each end of the guide-bracket assembly.
5.
Pivot the retention clips away from the guide-bracket assembly.
6.
Slide the SEC cartridge and heat sink assembly out of the guide-bracket
assembly.
DELL CONFIDENTIAL - Preliminary
'HOO 3RZHU(GJH 6\VWHPV
,QVWDOODWLRQ DQG 7URXEOHVKRRWLQJ
9/11/00