Dell PowerVault MD3000i Upgrade handleiding - Pagina 3

Blader online of download pdf Upgrade handleiding voor {categorie_naam} Dell PowerVault MD3000i. Dell PowerVault MD3000i 28 pagina's. Configuration for vmware esx server software
Ook voor Dell PowerVault MD3000i: Handmatig afstemmen (32 pagina's), Ondersteunende opmerking (22 pagina's), Gebruikershandleiding (46 pagina's), Vervangingshandleiding (4 pagina's), Configuratiehandleiding (10 pagina's)

6 Connect the expansion enclosures (if present) to the RAID controller

module you added in slot 1, as shown in Figure 2.

NOTE:

Wait for the enclosure status LED to turn blue before proceeding

to the next step.

7 In MD Storage Manager, click the Tools tab (for the storage array you are

upgrading).

8 Select Configure Ethernet Management Ports, then select Controller 1,

Port 1 in the Ethernet port menu.

9 Select Specify configuration.

10 Set the IP address, subnet mask, and gateway for Controller 1, Port 1.

11 Click New to add a new storage array.

12 In the Add New Storage Array window, select Manual and then click OK.

The Add New Storage Array – Manual window opens.

13 Select Out-of-band management.

14 In the RAID Controller Module (host name or IP address) fields, enter

the IP addresses of both the RAID controllers now in your storage enclosure.

Click Add.

When asked if you would like to add another storage array, click No.

15 Adjust the virtual disk caching options (in each example below, the

IP_address is the management port address of RAID controller 0):

Display a list of all virtual disks:

SMcli IP_address -c "show allVirtualDisks;"

For each virtual disk name shown, run the following command:

SMcli IP_address -c "set

virtualDisk[virtual_disk_name]

mirrorCacheEnabled=true writeCacheEnabled=true

readCacheEnabled=true;"