Dell PowerVault MD3060e Series Gebruikershandleiding - Pagina 28

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Dell PowerVault MD3060e Series. Dell PowerVault MD3060e Series 40 pagina's. Storage enclosure
Ook voor Dell PowerVault MD3060e Series: Handleiding voor hardware en software (25 pagina's), Installatiehandleiding (11 pagina's), Aan de slag handleiding (10 pagina's), Informatie-update (8 pagina's), Instructies voor installatie van het rek (2 pagina's), Instellen (2 pagina's), Uitrolhandleiding (24 pagina's), Handleiding voor beheerders (35 pagina's), Aan de slag handleiding (10 pagina's), Uitrolhandleiding (24 pagina's), Handleiding voor beheerders (48 pagina's), Instellen (2 pagina's)

CAUTION: If you are hot swapping the SAS cable chains, ensure that you complete the

procedure on one side within ten minutes to avoid over heating of the storage enclosure.

Locate and identify the SAS chain cables for the new physical-disk drawer.

Connect the chain cable mounting bracket (oriented horizontally) to the physical-disk drawer.

Connect the chain cable mounting bracket (oriented vertically) to the midplane.

Install the cooling fan module.

Repeat the above mentioned steps for the SAS cable chain on the other side.

Enclosure Management Modules

CAUTION: Many repairs may only be done by a certified service technician. You should only

perform troubleshooting and simple repairs as authorized in your product documentation, or as

directed by the online or telephone service and support team. Damage due to servicing that is

not authorized by Dell is not covered by your warranty. Read and follow the safety instructions

that came with the product.

CAUTION: To avoid damage to the sensitive EMI contacts on the module, do not stack the

modules.

Identify and locate the enclosure management module that you want to replace.

Disconnect the cables connected to the RAID controller module, enclosure management module, or

server.

Push down on the release tab and pull the release lever away from the chassis.

Hold the release lever and pull the module away from the chassis.